APURO FT691-A User manual

Model:
FT691-A/FT692-A/FT693-A/FT694-A/FT695-A
Bain Marie
Instruction manual
FT691-A to FT695-A_A5_v1_20220524.indb 1FT691-A to FT695-A_A5_v1_20220524.indb 1 2022/5/24 15:052022/5/24 15:05

2
EN Telephone Helpline: 1300225960
Safety Instructions
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• DO NOT immerse the appliance in water, or use jet/pressure
washers to clean it.
• DO NOT touch hot surfaces with bare hands. Always use the
handles/protective gloves.
• DO NOT overfill the appliance. Keep the water level below the
‘MAX’ level.
• DO NOT allow the water level to drop below the ‘MIN’ level
during operation.
• DO NOT move the appliance when it contains hot liquid.
• DO NOT use the appliance for anything other than its intended
use.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a danger or injury.
FT691-A to FT695-A_A5_v1_20220524.indb 2FT691-A to FT695-A_A5_v1_20220524.indb 2 2022/5/24 15:052022/5/24 15:05

3
EN
Telephone Helpline: 1300225960
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Warning: Opening the drain cock will lead to the outflow of
the hot contents of the Bain Marie.
• Apuro recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
Product Description
Model Tap Pans Pots
FT691-A
FT692-A
FT693-A
FT694-A
FT695-A
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Apuro product.
FT691-A to FT695-A_A5_v1_20220524.indb 3FT691-A to FT695-A_A5_v1_20220524.indb 3 2022/5/24 15:052022/5/24 15:05

4
EN Telephone Helpline: 1300225960
Pack Contents
The following is included:
• Apuro Bain Marie
• Pans 2 x 1/3 and 2 x 1/6 (FT691-A/FT692-A
only)
• Support bars (FT691-A/FT692-A only)
• 5.2 litre pots x 2 (FT695-A only)
• Instruction manual
Apuro prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your Apuro dealer immediately.
Operation
Power switch Thermostat Dial
Heat Indicator Light
1. Connect the appliance to the power supply.
2. Fill the tank with water to a level between the
‘MIN’ and ‘MAX’ marks on the inside of the
tank.
Note: Apuro recommend that fresh water
should be used each time.
3. Switch the power switch to the On position [I].
4. Turn the thermostat to the desired temperature
to heat-up the appliance. The heat indicator
light will turn on.
5. Once the appliance has heated the water, the
heat indicator light will turn Off.
6. Reduce the heat setting on the Thermostat to
maintain temperature.
WARNING: Do not allow
the water to drop below the
‘MIN’ level during operation.
Otherwise, severe damage to the
heating element could result.
Maintaining Water Levels
It is important to regularly check the water level in
the tank.
• Always keep the water level above the
‘MIN’ mark on the inside of the tank during
operation.
• Damage to the heating element can occur if
the tank boils dry and the element may have to
be replaced. This is not covered by the Apuro
warranty.
Emptying the Appliance
Note: Always switch the
appliance off and allow the
water to cool before emptying.
FT692-A/FT694-A - Turn on the tap to drain the
water. Ensure a suitable container is used to collect
the water.
FT6910-A/FT693-A/FT695-A - Use a suitable
container to remove the water from the appliance.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The thermal Cut-out switch is located on the rear
of the appliance. To reset the appliance after a
sufficient cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
using a blunt pointed instrument.
3. The appliance is now reset and can be used as
normal.
FT691-A to FT695-A_A5_v1_20220524.indb 4FT691-A to FT695-A_A5_v1_20220524.indb 4 2022/5/24 15:052022/5/24 15:05

5
EN
Telephone Helpline: 1300225960
Cleaning, Care & Maintenance
WARNING: Always turn off and disconnect the appliance from the power supply
before cleaning.
Always allow the appliance to cool before emptying or cleaning.
• Wipe down the exterior of the appliance with a damp cloth.
• Some cleaning agents may cause damage when used for a prolonged period on stainless steel. Use a
suitable stainless steel cleaner. Daily cleaning is recommended.
• Wash all removable parts in warm, soapy water.
• Dry the exterior thoroughly.
De-scaling
To maintain energy efficiency and prolong the life of the appliance, regular de-scaling is needed.
• Pour a solution of neutral cleaner and water into the appliance.
• Brush gently with a soft brush.
• Discard the solution and flush out thoroughly with clean water to remove any solution residue.
• Wipe dry the appliance, especially the bottom part of the water tank.
Note: Use a suitable cleaner and always follow the instructions on the cleaner
container.
Apuro recommend that this appliance is de-scaled every 3 months or more often
in hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault Probable Cause Solution
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Mains power supply fault Check mains power supply
Thermal cut-out switch has
activated
Reset Thermal cut-out switch (Page 4)
The thermostat has not been set
correctly
Set the thermostat to a higher temperature
The heating element has failed Replace heating element
FT691-A to FT695-A_A5_v1_20220524.indb 5FT691-A to FT695-A_A5_v1_20220524.indb 5 2022/5/24 15:052022/5/24 15:05

6
EN Telephone Helpline: 1300225960
Technical Specifications
Model Voltage Power Current
Product
Dimensions
H x W x D mm
Weight
FT691-A
220-240V~ 50/60Hz 1100-1300W 5.2A 246 x 340 x 598
10.4kg
FT692-A 10.7kg
FT693-A 7.8kg
FT694-A 8.1kg
FT695-A 10.5kg
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and environmentally safe
recycling process. For further information on how to dispose of this product correctly, contact the product
supplier, or the local authority responsible for waste disposal in your area.
APURO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
APURO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of Apuro.
Every effort is made to ensure all details are correct at the time of going to press, however, Apuro reserves the right to
change specifications without notice.
FT691-A to FT695-A_A5_v1_20220524.indb 6FT691-A to FT695-A_A5_v1_20220524.indb 6 2022/5/24 15:052022/5/24 15:05

DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade
Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp
• Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento
Model • Modèle • Modell • Modello
• Modelo • Malli
Bain Marie with pans
Bain Marie with Tap and Pans
Bain Marie
Bain Marie with Tap without Pans
Bain Marie with Round Pots
FT691-A
FT692-A
FT693-A
FT694-A
FT695-A
Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en) •
Application de la/des directive(s) du
Conseil • Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive
• Aplicación de la(s) directiva(s) del
consejo • Aplicação de directiva(s) do
Conselho
Electrical safety
IEC 60335-1:2010 +A1:2013 +A2:2016
IEC 60335-2-50: 2003 +A1:2008
EN 62233:2008
Electro-Magnetic Compatibility
EN IEC 55014-1: 2021
EN IEC 55014-2:2021
EN IEC 61000-3-2: 2019 +A1:2021
EN 61000-3-3:2013 +A1:2019
Producer Name • Naam fabrikant • Nom du producteur • Name des Herstellers
• Nome del produttore • Nombre del fabricante • Nome do fabricante
Apuro
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s)
and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und
Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y
estándar(es) arriba mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es)
Directiva(s) e Norma(s)
Date • Data • Date • Datum • Data •
Fecha • Data
25th April 2022
Signature • Handtekening • Signature
• Unterschrift Firma • Firma •
Assinatura
Full Name • Volledige naam • Nom et
prénom • Vollständiger Name • Nome
completo • Nombre completo • Nome
por extenso
Ashley Hooper
Brendan Denmeade
Position • Functie • Fonction • Position
• Qualifica • Posición • Função
Technical & Quality Manager
Commercial Manager/ Responsible
Supplier
Producer Address • Adres fabrikant •
Adresse du producteur • Anschrift des
Herstellers • Indirizzo del produttore •
Dirección del fabricante • Morada do
fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
15 Bagdally Road,
Campbelltown
NSW 2560
DocuSign Envelope ID: D8353821-783F-4B63-9166-4ACFE3F49C40
FT691-A to FT695-A_A5_v1_20220524.indb 7FT691-A to FT695-A_A5_v1_20220524.indb 7 2022/5/24 15:052022/5/24 15:05

FT691-A to FT695-A_A5_v1_2022/05/24
FT691-A to FT695-A_A5_v1_20220524.indb 8FT691-A to FT695-A_A5_v1_20220524.indb 8 2022/5/24 15:052022/5/24 15:05