aqua greek products Pull-Out Legrest User manual

Revised 2/28/18
Copyright © 2018 Aqua Creek Products All Rights Reserved
Pull-Out Legrest
Instructions
PART #: F-105LAR-01
MANDATORY
LEAVE THIS MANUAL WITH LIFT OWNER
Read and follow all instructions.
Lift safety can only be ensured if the lift is installed and
operated according to these instructions.
• NEVER permit children to play on or around the lift
• Do not allow children to use the lift without adult
supervision
• NEVER apply direct water pressure to the electronics
• NEVER use the lift with a dry pool
Check entire box and all packing materials for parts. Before beginning assembly, read the
instructions and identify parts using the fi gures and parts listed in this document.
It is critical that all parts be carefully inspected prior to installation. If any damage occurred in
transit, Aqua Creek Products, LLC must be notifi ed within three days of receipt of unit.
Proper installation cannot be overstressed, as an improper installation voids Aqua Creek’s
warranty and may affect the safety of the user.
READ CAREFULLY
9889 Garrymore Ln
Missoula, MT 59808
888-687-3552 | [phone]
www.aquacreek.com
1

Revised 2/28/18
Copyright © 2018 Aqua Creek Products All Rights Reserved
The pull out legrest assembly is designed to t under the chair and is installed inside the 2” square
tubing that supports the chair from underneath. To install the pull out legrest;
1. With a at-blade screwdriver, pry o the 2” square plug from the end of the 2”square tube of
the seat arm.
2. Drill a 9/32” hole at the location indicated in the drawing below through the bottom of the
chair support tube. Drill only through the bottom of the tube. Remove the burrs from the hole
before installing the legrest assembly.
Installation Instructions:
DRILL 9/32" HOLE
(BOTTOM OF CHAIR SUPPORT TUBE)
(SEE FIGURE TO THE RIGHT)
3/4"
1"
DRILL
9/32"
(THIS SIDE)
2" SQUARE
PLUG
SEAT SEAT ARM
2

Revised 2/28/18
Copyright © 2018 Aqua Creek Products All Rights Reserved
3. Orient the pull out legrest as shown below and slide the plastic guide/spacer into the chair support
tube. Tap the palstic guide/spacer with a hammer or mallet until ush with the end of the support
tube. The threaded hole in the bottom of the plastic guide/spacer should line up with the hole
drilled in the support tube. Install the washers and 1/4”-20 x 1/2” cap screw from underneath and
tighten until snug.
drilled in the support tube. Install the washers and 1/4”-20 x 1/2” cap screw from underneath and
tighten until snug.
1" SQ. TUBE
PLASTIC
GUIDE/SPACER
PULL OUT LEGREST
1/4" FLAT WASHER
1/4" LOCK WASHER
1/4" X 1/2" CAP SCREW
CHAIR SUPPORT TUBE
PLASTIC GUIDE/SPACER
FLUSH WITH 2" SQ. TUBE
The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put
the pad up and down to make sure everything works smoothly.
LEGREST
STOWED
LEGREST
OUT
LEGREST
OUT & UP
SLOT PIN
SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION
3