AQUAJAM AJ2 User manual

TM
USER MANUAL

1.
IMPORTANT!
THIS PRODUCT IS WATERPROOF ONLY IF THE INSTRUCTIONS ARE
FOLLOWED. AVOID SUBMERGING THE PRODUCT BELOW 1M AND ALWAYS
ENSURE THAT THE CHARGING CAP IS SECURELY LOCKED BEFORE USE.
ENG

The AQUAJAM is an extreme climate, oating,
waterproof, full range wireless speaker system with built-in
rechargeable battery. Stream & Play your music from your
Bluetooth enabled device such as a Smartphone, Tablet or Laptop.
Take and make phone calls thanks to the built-in microphone.
The design and oatation of the speaker will keep it positioned
upright when oating so you can enjoy your music in the pool, bath,
lake or sea. Clip on your bike, back-pack or other gear and you
have portable all weather music.
Carabiner Bike Mount 3M Tape Mount USB Charging Cable
What’s included:
Hand strap
AquaJam
2.
ENG

3.
TM
Safety Lock
Hidden LED
Microphone
Volume - &
Previous track
selection button
Power On/Off,
Play/Pause
& Answer call button
Volume + &
Next track
selection button
Protective Cap
Air Pressure Valve
Safety lock
Lanyard Hole
Accessory Mount
ENG

Quick Start
(pairing)
Power on: Press and hold Power ON/OFF button for 4
seconds, a sound prompt will indicate
the AQUAJAM is powered on.
The speaker performance and sound may vary when wet.
**For optimal performance the battery should be
fully charged before rst use.
1. The AQUAJAM will automatically enter pairing mode and begin
searching for other Bluetooth wireless enabled devices.
2. In the Bluetooth settings of your Smartphone, tablet, or media player
switch Bluetooth ON and select the option to“Search for Devices”.
3. Find & select (tap)“AQUAJAM”on your Smartphone/Tablet to complete a
successful pairing. (If prompted for a passcode use 0000.)
4. Once the pairing is complete and the Bluetooth connection made you will
hear a“beep” tone from the speaker.
5. Now navigate to your music player or music app, press play and enjoy
your music wirelessly.
6. For reconnection ensure Bluetooth is enabled and then press the ON/OF
button to power the speaker on and it will look for the last paired
device rst.
4.
ENG

Power On/O
Play / Pause &
Answer call button
POWER ON/OFF
1. Long press the button for approximately. 4 seconds a sound prompt will
indicate that the unit is powered on.
2. Long press the button for approximately. 4 seconds, a sound prompt will
indicate that the unit is powering down. the LED will turn o.
The unit is powered o.
3. Light press to PLAY or PAUSE the music.
4. Light press to answer incoming calls. (see page 7.)
5.
ENG

Volume + &
Next track
selection button
6.
Volume - &
Previous track
selection button
Long press to decrease
the Volume level
Light press to select
Previous song track
Long press to increase
the Volume level,
two short beep tones will
sound when max vol.
setting is reached
Light press to select
Next song track
VOLUME/TRACK SELECTION
NOTE: You can also control the track and volume on your
Bluetooth enabled device.
ENG

Microphone for answering calls:
- To answer a call press the button
- Talk over the built in microphone on the side of the unit
- For best results, speak within 50cm (20”) of the Microphone
during call
Hidden LED:
- Red LED will light up during charging, the LED will turn
o when charging is completed
- Blue LED will ash when the unit is powered on and is under
pairing mode
- Blue LED will ash twice intermittently once pairing is
completed and the AQUAJAM is connected to the device
ANSWERING CALL/LED INDICATOR
Microphone
Hidden LED
7.
Answer Call Button
ENG

The micro USB port is located under the USB cover, which is in turn is located
under the protective cap. Push the safety lock in and unscrew the protective
cap and then peel open the protective USB cover
to gain access.
Cap & USB Charging Connection
Rubber Gasket
Ring
Micro USB
Charging Socket
Top of the Unit
Warning:if the protective cap or the usb cover is o or loosely secured then the
speaker is NOT watertight and can cause damage to the speaker. To maintain a
watertight seal, make sure the USB cover is rmly sealed and the Protective Cap is
attached rmly to the top of the speaker and screwed on tight until the safety lock
is engaged.
Charging the Battery: Playtime lasts up to 10 hours on a full charge.
The built-in Lithium Ion battery uses the included USB cable to recharge for
optimal charging connect the USB cable to your computer or any
USB wall or car adapter that outputs a minimum of 5V @1Amp
or higher. The red LED will be solid during charging and turn o when
charging is complete. When battery energy is low, a sound prompt will
indicate with 30 minutes of approximate playtime remaining.
8.
Protective Cap
Protective USB Cover
ENG

Mounting
Hole Cover
The AQUAJAM comes with a 3M multipurpose mount and a
Bike Mount.
Accessory Mounts
Accessory Mount
Bike
Mount
Bike Handlebar
Mount
3M Multipurpose
Mount
Back of the Unit
9.
Lanyard Hole
ENG

THE 3M MOUNT IS AN INDUSTRIAL STRENGTH WATERPROOOF
MOUNT. It can be used on a variety of surfaces and in outdoor
environments.
To remove the adhesive mounts, you can use a hairdryer or
heat gun to soften the adhesive and slowly peel it back.
Please note that you will not be able to reuse an adhesive
mount once you remove it.
Installing the 3M
Multipurpose Mount
1. To install a mount remove the mounting hole cover,
unscrew it from the speaker.
2. Once the cover is removed take the Mount and twist it 90 degrees in
a anticlockwise motion into the accessories mounting hole. Make sure
the mount is securely attached to the speaker.
3. Apply the mount to a smooth, and fully cleaned surface.
A textured surface or any imperfections to a smooth surface can
keep the adhesive from making a strong bond.
4. Firmly press the mount into place ensuring full
contact over the entire surface area.
5. Be sure to apply the mount at room temp, and also allow at least
24 hours for the mount to properly adhere to the surface.
10.
ENG

- If you are mounting the speaker onto a surboard don't
mount to soft-top boards as they are porous and the mount will
not adhere properly.
- It is typically not recommended to use adhesive mounts on skis or
snowboards as the ex and vibration caused can sometimes lead to
the mount coming loose. Failure to follow these guidelines may result in
loss or damage of your speaker, which is not covered under warranty.
Notes
Instaling the Bike Mount
1. Use a (Philips) screwdriver to fasten the bike mount onto the handlebar
of the bicycle. Depending on the size of your handlebar frame you can
insert the pads provided to ensure a tight t.
2. Fasten the speaker onto the mount by rotating 90 degrees
anticlockwise.
ENG
11.

Microphone
Bluetooth Wireless Range In A Dry Environment
The AQUAJAM has a wireless range of up to 10 meteres. To get the
best reception ensure there is a clear line of sight between your
AQUAJAM and your bluetooth enabled device. Obstructing objects
between your AQUAJAM and your device may compromise the range
and cause interefrence with your connection. For best results ensure
that your phone is pointed directly at the AQUAJAM logo on the front
face of the unit. To get the best audio quality, ensure the speaker grill
is facing you and The unit is either positioned on its side grips or upright
on the base grip.
Bluetooth Wireless Range In A Wet Environment
As water absorbs bluetooth signals the wireless range will
lessen when the AQUAJAM comes into contact with water. To
maximise the range ensure that there is a clear line of sight
between your Bluetooth enabled device and the AQUAJAM.
The aquajam is designed to oat. To enjoy the best audio
quality try to avoid unnecessarily submersing the product.
Do not submerse the product below 1 meter .
12.
Tips To Get The Best Reception
And Audio Quality ENG

1. Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus that produce heat.
2. For protection during lightning storm, unplug the speakers from
the electrical outlet and turn o the computer.
3. Unplug this apparatus when unused for long periods of time.
4. Place the AQUAJAM in a stable location so that it will not fall
causing damage to the speakers or bodily harm.
13.
Care & precautions
Audio Quality In A Wet Environment
If water enters the speaker grill the audio quality will be
temporarily compromised. To resume normal sound hold
the speaker upright allowing for the water to drain out of the
grill. The speaker should dry up quickly and normal audio
quality will be restored.
ENG

5. Close the CAP and USB cover properly before use, tightly
screw in the CAP. If the unit is placed in water
without the cap the warranty will be invalid.
6. Dry unit completely before opening the cap. Do NOT open the
cap if wet or in a wet environment. Do NOT use or store the unit in
places with high temperature.
7. Avoid direct exposure to sunlight and strong magnetic elds.
8. Periodically check the rubber gasket ring on the unit for premature
wear.
9. Periodically clean the rubber gasket ring with a soft moist
cloth. Do not use any oily solvent or chemi-cals for cleaning.
10. Rinse o the unit with tap water after use in salt water or
swimming pool.
11. Audio distortion may occur when the batteries are nearing
end of charge.
12. Avoid hard impact of the handle bar when a speaker is
attached on the bike mount; the speaker may be detached
& damaged.
14.
Care & precautions ENG

15.
IMPORTANT !
CET APPAREIL RESTE IMPERMÉABLE AUX INFILTRATIONS D'EAU TANT
QUE VOUS RESPECTEZ NOS INSTRUCTIONS. ÉVITEZ DE DESCENDRE VOTRE
APPAREIL À PLUS DE 1 M SOUS L'EAU ET VÉRIFIEZ TOUJOURS QUE LE CAPUCHON
DE PROTECTION EST CORRECTEMENT VERROUILLÉ AVANT TOUTE UTILISATION.
FRA

AQUAJAM est une enceinte acoustique pleine gamme sans l
avec accu rechargeable intégré. L'enceinte est imperméable et
otte sur la surface de l'eau. Vous pouvez écouter la musique d'un
téléphone mobile compatible avec Bluetooth (ou d'un autre
appareil audio compatible avec Bluetooth) avec l'enceinte. Grâce au
microphone intégré, vous pouvez aussi téléphoner avec l'enceinte.
Vous pouvez attacher l'enceinte au vélo ou au sac à dos, et écouter
ainsi la musique pendant vos activités en plein air sans l et par tous
les temps.
Porte-
mousqueton Support vélo Support
auto-adhésif Câble de recharge USB
Accessoires fournis:
Cordelette pour le poignet
AquaJam
16.
FRA

17.
TM
Verrou de sécurité
Témoin DEL de
l'état de fonctionnement
Microphone
Réglage du volume(-)
& retour au titre
précédent
Mise en marche/arrêt;
lecture/pause &
téléphoner
Réglage du volume (+)
& passage au titre
suivant
Couvercle
de protection
Air Pressure Valve
Verrou de sécurité
Trou d'attache
Dispositif d'attache pour
les accessoires
de montage
FRA

Etablir la connexion
Bluetooth (Pairing)
Mise en marche: Maintenez appuyée la touche de mise
en marche pendant 4 secondes. Vous entendez un signal
acoustique et l'enceinte acoustique est allumée.
La performance de l'enceinte et la qualité du son changent
probablement lorsque l'enceinte est mouillée.
**Pour un fonctionnement optimal de l'enceinte,
il faut entièrement charger l'accu avant l'emploi.
1. Après avoir allumée l'enceinte acoustique, elle se trouve en mode pairing
et cherche des appareils audio compatibles avec Bluetooth.
2. Commencez la recherche des périphériques sur votre téléphone mobile
(ou sur un autre appareil compatible avec Bluetooth).
3. Choisissez le nom de périphérique "AQUAJAM" de la liste des appareils
couplés avec le téléphone. Entrez les chires "0000" si vous avez besoin
d'un mot de passe.
4. Vous entendez un signal acoustique lorsque la connexion est eectuée
avec succès.
5. Commencez la lecture de musique sur votre téléphone mobile.
6. L'enceinte cherche automatiquement le périphérique qui était connecté
en dernier lorsqu'elle est remise en marche.
18.
FRA

Mise en marche/arrêt
Lecture/pause &
Téléphoner
Mise en marche/arrêt
1. Pour allumer le haut-parleur, appuyez sur la touche et maintenez-la
enfoncée pendant, environ, 4 secondes, jusqu'à entendre une tonalité.
2. Pour éteindre le haut-parleur, appuyez sur la touche et maintenez-la
enfoncée pendant, environ, 4 secondes, jusqu'à entendre une tonalité.
Le témoin DEL de marche s'éteint.
3. Appuyez brièvement sur cette touche pour commencer la lecture et pour
l'interrompre momentanément.
4. Appuyez brièvement sur cette touche lorsque quelqu'un vous
appelle sur votre téléphone mobile pour répondre à l'appel.
19.
FRA