Aquaporin ZERO Parts list manual

FILTER
REPLACEMENT
GUIDE

The following instructions apply to the
replacement of the pre- and post-lters
as well as the RO lters in ZERO.
• Replace the cartridge no later than 12 months
from the date of installation.
• Replace the battery (DL2032) of the LED indicator
each time you replace the cartridge.
• If the system is left idle for more than 60 days,
it is recommended to replace the lters.
See installation video, Q&A and more
on www.aquaporin.com/installation or
scan the QR code

Turn the
faucet on.
Turn off the cold
water valve.
Dispense 3 liters
of water to empty
the tank.
1 2 3
Open the lid.
4

Remove the inside cover by
pinching gently on the inside
and outside of the cover and
remove it as shown on the
illustration.
6
Remove pre- and post-
lter by unscrewing them
counter-clockwise and
pull down.
5

7
8
Remove the two RO
lters by unscrewing
them counter-clockwise
and pull down.
Before you insert the new
RO lters, wet the O-ring.
Insert the new RO lters by
pushing them in and tighten
by screwing clockwise.

Before you insert the new pre-
and post-lters, wet the O-ring.
First, insert the post-lter
followed by the pre-lter by
pushing them in and tighten by
screwing clockwise.
10
Put the internal cover
back on.
9

11 12
13
Put the lid
back on.
Turn on the cold
water valve.
After replacing the lters the system must be ushed before
consuming the water. This is done by leaving the faucet open
for 15 minutes. The water ow will be slow since the tank is
empty. When you close your faucet after 15 minutes the tank
will start to ll.
If you experience noises from your ZERO it can be caused by
air in the machine. Please follow the steps in the USE section
in the installation guide.

Aquaporin A/S
Nymøllevej 78
2800 Kongens Lyngby
Denmark
Tel: [phone]
[email protected]
aquaporin.com/zero
ZERO-Filter-Replacement-Guide Revised: 16 Dec 2020