AQUARISTIK PRO CAL 80 User manual

PRO CAL
80/150/400
Calcium Reactor
Setup
Guide
PUMP WARRANTY REACTOR WARRANTY
www.sraquaristik.com

www.sraquaristik.com page 1 of 4
STEP 2
Adding Calcium Reactor Media
Wash and add media Add plastic separator on top
STEP 1
Calcium Reactor Body Construction
Install pump to the reactor.
Connect the top arm plumbing Connect the arm plumbings
Connect the bottom arm plumbing

www.sraquaristik.com page 2 of 4
STEP 4-A
For DC Pump Set Up
Pump Input Connection
Recirc. pump Input pump
set to 1%~5% coming out from the reactor
Adjust the amount of water
set to 15%~30%
Output connection to sump w/ valve
Fine adjustment valve to sump
STEP 3
Co2, pH, and Recirculation Connections
CO2 connection Recirculation pH probe

STEP 4-B
For Peristaltic Pump Set Up
Peristaltic Pump
Reactor to pump
as water is being controlled through the peristaltic pump
Fine adjustment valve is not necessary
Pump to sump set to 15%~30%
Recirculation Pump
Input connection from sump w/ valve
www.sraquaristik.com page 3 of 4

STEP 5
Dialing in Reactor
set to 6.4 ~ 6.1
pH controller
set CO2 to 40psi Your setup is now ready to use!
Calcium Reactor full setup
www.sraquaristik.com page 4 of 4