Aquatic AQ-RF-6UBT Series User manual

Please check first that the package contains all of the items below. If something is missing,
contact the store where you purchased the product.
• Remote Control RF Handset (AQ-RF-6UBT-T)
• RF Receiver (AQ-RF-6UBT-R)
• Charging Cable
Contents
The remote has a built-in Polymer Lithium rechargeable battery and comes with a charging cable.
Connect one end of the charging cable to the charging connection on remote control and connect
the USB end of the charging cable to any USB charger (5V DC) for charging.
Make sure the remote has been charged before used.
Charging the Remote Control
The remote should already be paired from the factory, but if you need to synchronize the remote,
follow the steps below.
1. Connect the receiver dongle to the female DIN connector of the Aquatic AV stereo before the
stereo is powered ON.
2. Turn the power to the stereo ON and hold the remote control close to the stereo.
3. Press and hold MODE on remote control until the LCD shows “Pairing in Progress” and then
release the button.
4. The remote’s LCD should display “Paired” wIthin 2 seconds to verify pairing has been suc-
cessful. If it fails to pair, the LCD will display “Retry again”. If this happens, wait 5 seconds and
repeat the above procedures.
Synchronizing the Remote Control
AQ-RF-6UBT
WATERPROOF REMOTE CONTROL
PLEASE READ THESE INSTRUCTIONS
BEFORE OPERATION
If the pairing process is not successful, try again to put your remote close to the remote receiver.
Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD
shows nothing, the battery has been drained and will need charging.
Aquatic AV, 282 Kinney Drive, San Jose, CA 95112, USA. [e-mail] - US & Canada: 1 877 579 2782 - Int: [phone]
www.aquaticav.com

Remote Control Operation
The AQ-RF-6UBT Remote Control is supported
by all Aquatic AV ‘6-series’ stereos however USB
and FM radio will only be available if your stereo
supports these functions.
For more information please refer to your stereo’s
user manual.
Buttons AUX Mode Bluetooth Mode USB Mode FM Radio
Power Press once: Toggle Operational mode to Standby or vice versa
Mode/
Pair
Press once: Change the mode (audio source)
Press and hold: Pair remote with stereo
Volume
Up
Press once: Volume up
Press and hold: Fast volume up
Volume
Down
Press once: Volume down
Press and hold: Fast volume down
Fast
Forward
Press once: No function
Press and hold: No function
Press once: Next track
Press and hold: Fast forward
Press once: +0.05kHz
Press and hold: Scan up
Fast
Rewind
Press once: no function
Press and hold: no function
Press once: Previous track
Press and hold: Fast rewind
Press once: -0.05kHz
Press and hold: Scan down
Play/
Pause
Press once: Toggle Mute
Press and hold: no function
Press once: Play/Pause
Press and hold: No function
Press once: Toggle Mute
Press and hold: no function
1Press once: no function/activate Pop EQ mode*
Press and hold: no function
Press once: Folder up
Press and hold: no function
Press once: Preset 1
Press and hold: Save to preset 1
2Press once: no function/activate Rock EQ mode*
Press and hold: no function
Press once: Folder up
Press and hold: Random playback
Press once: Preset 2
Press and hold: Save to preset 2
3Press once: no function/activate Classical EQ mode*
Press and hold: no function
Press once: Folder down
Press and hold: no function
Press once: Preset 3
Press and hold: Save to preset 3
EXT
Trigger
Press once: External Trigger 1
Press and hold: External Trigger 2
Audio Press once: Enter Audio menu
Press and hold: Save and exit Audio menu
VBass Press once: Toggle Virtual Bass On or Off
Press and hold: no function
If your music player is connected via the AUX input you will be unable to control track or receive track information.
To prevent battery life the LCD will shut off after 5 seconds if no other button is pressed. To tun back on press any
button once.
DSP (Pop, Rock and Classical) will be turned off when bass and treble are set.
When in Bluetooth mode, Repeat and Random playback must be enabled on your device for correct operation.
*Applies to Aquatic AV stereo models AQ-BC-6BT and AQ-DM-6BT.
The Audio menu must be exited before using all other modes.
Remote Control Operation 2 Channel Waterproof Amplifier AQ-AD300.2-MICRO
Aquatic AV, 282 Kinney Drive, San Jose, CA 95112, USA. [e-mail] - US & Canada: 1 877 579 2782 - Int: [phone]
www.aquaticav.com