ARCHIPELAGO LIGHTING planoARCH LBLP quinceARCH User manual

archipelagolighting.com
[phone]
- Please read the product specication carefully rst to conrm
that the working environment is in line with the condition on the
specication before it is used.
- Please conrm the input voltage and frequency before use.
- The light must be installed by professional personnel
- If the power cord and case of the products are damaged, it will be
regarded as disqualied product and should not be used.
- If the external soft cable or wire of the product is damaged, the
wire should be replaced by the manufacturer or service agent or,
personnel with similar qualications to avoid danger.
- This luminaire is designed to operate in ambient temperatures ranging
from -10°F to 125°F and to be horizontally mounted facing down.
- This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation
of the product and the hazards involved.
- This product is not available for several special environments, such as
places with corrosive gas liquids or high pressure water vapor.
- CONSULT A QUALIFIED ELECTRICIAN TO ENSURE THE CORRECT
BRANCH CIRCUIT CONDUCTOR
- CAUTION - RISK OF FIRE
Please read all the instructions before attempting installation
Lay-in Installation
Suspended Installation
|Headquarters: 4615 State Street, Montclair, CA 91763
| Production Center: 7345 Sycamore Canyon Blvd, Riverside, CA 92508
1. Fix the suspension wire xer
on the ceiling
1. Cut o the power supply before installation.
2. Ensure that the installed object can bear
the xture weight.
3. Open the groove on the ceiling according
to corresponding size. Then install the lamp
into the clamping groove on the ceiling.
4. Then connect wire attached to the
light onto the corresponding power cord
and carry out insulation sealing at the joint.
2. Fix the suspension wire on the ceiling 3. Connect LED panel light by the
hook of suspension wire
LBLP | quince Ⓐ RCH - Installation Guide
Fix screw
Ceiling
LED driver box
LED panel
light
Adjust the length
of suspension wire
Suspension
wire
Drill a hole with 6mm
diameter drill bit
Suspension wire xer
Inatable Colloidal
particle
Rotary xing

archipelagolighting.com
[phone]
Surface Mount Installation
|Headquarters: 4615 State Street, Montclair, CA 91763
| Production Center: 7345 Sycamore Canyon Blvd, Riverside, CA 92508
1. Parts A1, A2, B1, B2
3. As is shown in the gure, x A1 and A2 on the ceiling or on the
roof, and then insert the Back-lit panel light directly (the end with
the power source enters later)
2. First install A1, A2, and B1 (as illustrated)
4. Install B2, nish installation
LBLP | quince Ⓐ RCH - Installation Guide
* 2 (A1/A2)
(A1)
(A1)
(A2)
(A2)
(A2)
(B1)
(B2)
(B1)
* 2 (B1/B2)
Ceiling
Ceiling Ceiling
LED panel light