Arctic P604 Wireless Operating and safety instructions

Example: Android 4.0
Press Menu > Settings > Switch on Bluetooth >
Bluetooth > Search for devices > P604 Wireless > Pair
Notes:
- Pairing mode will last up to ten minutes or until a device is
found, two tones will sound to let you know when pairing has
stopped.
- If you exceed the effective range of approx. 10M (33ft) the
headphone will disconnect and will automatically reconnect if
the speaker re-enters the effective range within ten minutes.
Phone Operations
If the mobile device that is paired (via Bluetooth) with the
P604 Wireless headphone is a cellular phone you can:
LED Indicators
Status
Charging
Battery Full
On and Paired
Paring Mode
Low Battery
Indication
Red LED on
Blue LED on
Blue LED flashes
Red and Blue LED will flash alternately
Red LED flashes
Reconnection
1. Turn on Bluetooth on phone.
2. Switch on the P604 Wireless by pressing the
multifunction button for 3 seconds.
3. If your device was the latest one to be paired with
the P604 Wireless it will connect automatically
otherwise please repeat pairing section.
Answer Call Press the once.
End Call Press the once.
Refuse Call Press and hold for 2 seconds.
Switch Call Press and hold for 2 seconds
while in a call.
OFF
Switch On
Bluetooth
ON
Select
P604 Wireless
P60 4 Wirel ess
ON
Click Search
for Devices
Click
Settings
ON
Bluetooth
is On
ON
Now
Connected
P60 4 Wirel ess
Select
Bluetooth
Click Settings
Bluetooth
is On
Select
P604 Wireless
P604 Wireless
Switch On
Bluetooth
Now
Connected
P604 Wireless
Example: iOS
Press Settings > Bluetooth and switch Bluetooth on
> P604 Wireless > Pair
Switch on
Press the multifunction
button for 3 seconds until
the blue LED lights up
Switch off
Press the multifunction
button for 3 seconds until
the red LED lights up
Function Diagram
Getting Connected
The P604 Wireless allows you to pair with your mobile
device in 2 different ways:
Charging the headset
It is recommended to fully charge before initial use for
better battery life.
USB Chargers are available at
chargers.arctic.ac
The P604 Wireless can be charged while switched on
or off.
1. Insert the micro USB cable into the P604 Wireless
and the USB side into a power source.
2. When the Blue light on constantly the P604
Wireless is fully charged.
Music Stutters
4
5
6
Switch On / Off
multifunction button
LED indicator
Micro-USB charging
Microphone
Previous track
Next track
Smart
Charger
4800
1. Switch on the P604 Wireless by Press the
Multifunction Button for 3 seconds.
2. The P604 Wireless automatically enters pairing mode
shown by the red and blue LED flash alternately.
3. Turn on Bluetooth on your phone and pair it with the
headphone.
A. Bluetooth Pairing
1. Switch on the P604 Wireless by Press the
Multifunction Button for 3 seconds.
2. Enable NFC on your mobile device.
3. Slide your phone very slowly from top to bottom
across the shown area of the right side of the
headphone until you hear a beep and a confirmation
message comes up on your mobile device.
4. Play music!
B. NFC One Touch Pairing
(only for NFC enabled phones)
NFC antenna
How to wear the headset
Switch the Headset On or Off
ButtonsButtons