User’s Manual –AREBOS Air Compressor 24L
6
damage or rust, contact a qualified professional.
•Danger of burning! Compressors and lines reach high temperatures during operation.
Touching leads to burns.
- Do not touch the compressor and lines during operation to avoid burns.
- Be careful when working.
•The gases or vapors sucked in by the compressor must be kept free from any admixtures that
could cause fires or explosions in the compressor.
•Wear safety glasses and respiratory protection when working with the blow gun. Foreign
objects, blown-off parts, and swirled-up dust can easily cause personal injury and damage to
health through inhalation. Dust-raising work should be carried out outdoors.
•Warning: All hoses and fittings of road-going compressors must be suitable for use on
construction sites at the maximum permissible pressure.
•Avoid heavy loads on the piping system by using flexible hose connections to prevent kinking.
1.4 Safety instructions for paint spraying
•Do not use paints or solvents with a flash point of less than 55 ° C.
•Do not heat paints and solvents.
•If harmful liquids are processed, filter devices (face masks) are required for protection. Also
note the information provided by the manufacturers of such substances about protective
measures.
•The information and markings of the Hazardous Substances Ordinance applied to the outer
packaging of the processed materials must be observed. If necessary, additional protective
measures must be taken, in particular appropriate clothing and masks to wear.
•Do not smoke during the spraying process or in the working area. Also paint vapors are easily
combustible.
•Fireplaces, open light or sparking machines must not be present or operated.
•Do not store or consume food and drinks in the work area. Paint fumes are harmful.
•The working space must be greater than 30 m³ and sufficient air exchange must be ensured
during spraying and drying. Do not splash against the wind. Always observe the regulations
of the local police authority when spraying combustible or dangerous injection-molded parts.
•Do not use media such as white spirit, butyl alcohol and methylene chloride in connection
with the PVC pressure hose (reduced service life).
1.5 Safety instructions for the compressor
•DANGER! For your own safety, operate the compressor only after reading the safety
instructions.
•Risk of explosion! If you operate the compressor in an unsuitable, poorly ventilated place, in
an unsuitable ambient temperature, or in a room containing dusts, acids, vapors, or
flammable gases, there is a risk of explosion.
- The compressor must not be operated or stored in a room containing dusts, acids, vapors or
flammable gases. He can explode.
- Keep away easily flammable substances from the compressor.
- Keep the gases or vapors sucked in from the compressor free of any impurities that could
cause fires and explosions in the compressor.
- Operate the compressor only at an ambient temperature of at least 5°C and at a maximum
of 40°C. At temperatures below 5°C, the motor startup is endangered by stiffness.
- Ensure that the ambient temperature in a closed working environment is not higher than
25°C to ensure proper operation of the compressor while maintaining full air charge.
- Only operate the compressor in well-ventilated areas.
- Do not spray water or flammable liquids on the compressor.
•Risk of injury! The compressor's compressed air tank is under pressure during operation and
