Arec AM-500 User manual

AREC AM-500 Quick Start
Specifications:
AM-500 Wireless Microphone Positioner
Front function key Stop tracking and Mute function
Effective range of microphone A circle of 12 meter radius
Sound input 3.5 audio input ack
Power supply AAA dry cell X 2 (Duracell alkaline battery recommended)
Power consumption estimates 6 to 8 hours (Duracell alkaline battery recommended)
Dimension 41.5mm(L)x21.5mm(W)x94mm(H)
Weight 45g
Wireless microphone positioner information
1. Upper front: Mute button and light indicator
2. Lower front: Stop tracking button and light indicator
3. Upper right side: Power switch and light indicator
4. Lower right side: Wireless mic. pairing light indicator
5. Left side: 3.5 audio input ack
Light indicators of your wireless microphone
AR C wireless mic. Light Color Status
Upper front Red Muted
Lower front Red
Auto tracking function suspensive
Press and hold for more than 5 sec. to reset to static IP
address and the light flashes red
Upper side Red & Green The light turns green then turns off after power ON
The light turns red when power is low
Lower side Blue
The light flashes blue intermittently if without paired device
The light flashes blue fast when pairing with one device
The light flashes blue slowly when paired with one device
successfully

Federal Communication Commission interference statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antenna. -Increase the separation between the
equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is sub ect to the following two
conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause
undesired operation
RF Exposure Warning
The equipment complies with RF exposure limits set forth for an uncontrolled environment. The
antenna(s) used for this transmitter must not be co-located or operating in con unction with any
other antenna or transmitter.
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.