argon audio Sub8 User manual

Sub8
OPERATING
INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS
Before using this subwoofer, please read the following instructions carefully
observing all the safety hints. Please keep this manual in a safe place for future
reference.
1) Keep the power cords well protected, i.e. do not allow heavy objects to crush the
cable or leave it twisted as this may cause the cable to fray resulting in electric shock.
If you must use an extension cord, please try to keep the length to a minimum.
Common sense applies to all things electric and this subwoofer is no different in this
regard.
2) Do keep this unit in a well ventilated place making sure no drapes or other
items are placed on top or near the subwoofer as the amplifier can get quite warm
and indeed hot if the unit is not kept well ventilated. Do not place any other
objects on the subwoofer like a vase because low frequencies generated by this
subwoofer can and will move anything placed on top of the unit and can result in
spilt water. This can severely damage the unit and cause electric shock.
3) If this unit requires servicing, do not attempt to repair it yourself. Always refer
service to an authorized Argon audio service centre. High voltages are located
within the cabinet which can result in serious injury.
4) Should you notice any malfunction including a burning smell, please switch
the unit off, remove the power plug from the wall and refer the unit to your
nearest Argon audio service centre.
5) Argon audio subwoofers are designed to operate on AC240V /50/60Hz power
supply which is standard in Europe. Do not attempt to operate on any other
voltage.

TO THE CUSTOMER:
Thank you very much for purchasing this Argon audio subwoofer.
We have designed this product to be extremely easy to operate but do read the
instructions carefully to maximize your long term enjoyment. Be sure not to overload
the speakers which can easily happen if the volume is set too high. If you notice
distortion please turn the volume down quickly as permanent and expensive damage
can be caused by overloading which is not covered by warranty. You can check this
out by going to our web page www.argonaudio.com.
Rear panel Connection
Rear panel Connections of Sub8:
1) High level inputs
2) Volume knob
3) Crossover frequency control
4) Phase control
5) Power indicator
6) Power switch on/auto
7) Line in / 5.1 Subwoofer input
8) Line input
9) High level outputs
10) Power switch
11) Power cable
12) Fuse housing (T1A/250V)

FUNCTION
Output power: 80w
Sensitivity: 72dB
Input sensitivity: 110mv
Frequency response: 40Hz-200Hz + - 3dB
Power supply: AC 240V /50/60 Hz
HANDY HINTS
Although your subwoofer comes with high level inputs and outputs these are ideally
only used for older amplifiers or receivers which do not have the sub-out facility. If
you do have this facility, then connect the subwoofer from sub out on the
amp/receiver to either of the line inputs. In some circumstances you will notice an
improvement in the subwoofer’s performance if you use a single line out to a double
line in from the amp/receiver to the subwoofer. These connections are readily
available from all hi-fi shops of any note. The line output allows you to connect a
second subwoofer should you desire to do so. Simply run another wire from the line
outputs to the line input or line outputs of the second subwoofer. If you are using a
second subwoofer it is recommended that you place them on either side of the room,
roughly in line with the tower/front speakers and at least one metre clear of a CRT
television receiver.
Please note that although this subwoofer is fitted with a phase control it is highly
unlikely that you will need to adjust it. Try, with only the subwoofer operating, to
rotate the knob and settle on the setting which gives you the most/the best bass, i.e.
when it is in phase. The factory setting is correct in 99% of all cases. Do avoid
playing with only the subwoofer operating for extended periods of time as this can
cause damage to the amplifier and/or the speaker drive units.
Should you have any further queries please contact either the retailer you purchased
this unit from or us on [e-mail]
Once again thank you for purchasing an Argon audio product and we trust you will
have many years of trouble free service.