a. Do wiring according to connection diagram
b. Wake up the remote control by touching ON/OFF button.
c. Press learning button on receiver.
d. Touch any zone button on remote control.
e. Then touch color wheel.
f. Connected LED light will blink to conrm zone designation.
g. Press at learning button on receiver over 5 seconds until LED light ash, then delete the learned
ID.
Note 1:
•Tochooseamasterfromslavesbyjumperforeachzone.
•Shortcircuitformaster.
•Opencircuitforslave.
•Eachzoneonlycansetonemastercontroller.Afteraperiodoftime,themasterwilldosynchronization
operationtokeepthesamecolorormodeofallslavesinonezone.
Note 2:
•Eachremotecontrol4zones(areas)receivers,eachareacanbelearnedasmanyreceiversaswecan.
•Eachreceivermaximallycanbecontrolledby8differentremotecontrollers.
Choose zone number , for example, and , then touch , choose the color you
want, zone 1 and 3 will indicate corresponding color as we touched.
Short/Long press button to dim down brightness of RGB channels, Short/long press button
to dim up RGB channels.
“W” channel is separated from RGB channels, so we can only long press button to dimming“W”
channel.
a. Short press ,mode will run. Press it once, it runs one mode. Press button again, it stops,
then press one more time, it will enter next mode. There are total 10 build-in modes.
b. Long press when mode is running, Fist long press will speed up the color moving, long
press again to speed down the color moving.
a. RGB channel will mix to three different white: warm white, nature white and cold white by short
press For example: rst press---warm white, press again---nature white, third press again—
cold white, fourth
press—warm white………………
b. Fast click twice to switch off RGB channel.
a.
b.
c. Recall: select zone button which we want recall from 1-4, then short press save button S1,S2,S3.
