Armitage Shanks Contour 21 User manual

H 2
H 1
Y
1
3
2
4
CONTOUR 21
1
Y
Check / measure top of key hole
positions in back of Trough.
Carefully drill wall. Insert and tighten fixations to ensure expansion
sleeves are ‘locked in’.
Transfer those positions to wall to give required
front rim height. Mark positions on wall.

2
IMPORTANT NOTE:
It is vitally important that when fixing the Wash
Trough to a solid wall, substantial fixings (such as
the Fischer TA M6 S/10) are used in the two key-
hole anchor points. Failure to do so could result
in the Wash Trough falling from the wall.
The bolts used in the keyholes can be adjusted
after the trough has been hung, this can help
reduce the gap to wall. This can be done via cut
outs in the plywood sub frame.
Bolt under head distance to wall needs to be sucient to accommodate thickness of trough
material. Ensure fixing points are level and bolts are fully anchored into wall. Z
Z
5Remove front access panel.
6Mount Trough, ensuing fixations are fully located in keyholes and wall fit is acceptable,
check heights/levels.

7
3
Going underneath Trough,
mark positions on wall of holes in L brackets.
8Remove Trough. 9Drill and plug L bracket holes in wall.
10 Mount Trough and screw to wall.
a
b
a
b

11
4
Version 1.0 | August 2019
We pursue a policy of continuing improvement in design and performance of our products. The right is, therefore, reserved to vary specifications without notice.
CUSTOMER CARE HELPLINE
[phone]
FAX LINE [phone]
email: [email protected]
If required, tighten key hole fixing points through gap in back (underneath Trough).
12 Replace front panel.