Artcobell Alphabet User manual

02.12.15 | Rv3
ALPHABET | INSTALLATION INSTRUCTIONS
Applicable Base Models:
ATT Tops
ATLI Leg Kits
1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching
2. Align the leg assembly keyholes with the 4 shoulder screws as shown below in Figure 1.
3. With the I-Leg assembly now placed over the shoulder screws, slide the leg assembly in the direction indicated
below in Figure 2. (IMPORTANT –SEE NOTE ON REVERSE SIDE)
Under Seat Wire Book Basket
Table Tops and Leg Kits | I-Leg
Slide I-Leg Assembly
Start Position
Final Position
Figure 1
I-Leg Assembly Keyhole
Shoulder Screw
Figure 2

02.12.15 | Rv3
ALPHABET | INSTALLATION INSTRUCTIONS
NOTE: Some resistance sliding the I-Leg Assembly to its final position may be encountered. This should be
considered normal. Use of a plastic or leather mallet to aid assembly is permissible if used as shown
below in Figure 3.
4. Install the ¼-28 x 5/16” T-30, Torx head Lock Screw provided in the hardware kit with the T-30 Torx driver as
shown below in Figure 4.
5. Adjust leg to desired height. (Leg comes preset to a 29” table height)
Lock Screw
Figure 3
Figure 4
Use mallet here