Bradley SIMPLE FRENCH User manual

thebradleycollection
SIMPLE
FRENCH
Installation Instructions
CONTACT
Web www.bradleycollection.com
Email [email protected]
Follow
WORLD
The Bradley Collection Ltd
Lion Barn • Maitland Road
Needham Market • Suffolk
IP6 8NS • UK
Telephone [phone]
Fax [phone]
USA & Canada
The Bradley Collection Inc.
3625 Hayden Avenue, Suite E
Culver City • CA • 90232 • USA
Telephone [phone]
Fax [phone]

Single Brackets
To align the brackets, the top of the passing brackets should
be fitted below the top of the side brackets. (see dimension Z)
Bracket positioning and fixing
Side brackets should be positioned approximately 100mm (4”) in from the end of the pole.
Tools
For the installation of the system the following items may be required.
SIMPLE
FRENCH
Installation Instructions
THANK YOU FOR YOUR ORDER
Before fitting this product please ensure
that you have thoroughly read these
instructions.
We have taken every care to design and
manufacture a quality system; incorrect
installation could lead to poor
performance.
If any queries arise when reviewing these
instructions or during installation please
feel free to contact us for assistance.
We will be glad to talk you through the
process.
Please retain these instructions for future
reference.
CONTACT
Web www.bradleycollection.com
Email [email protected]
World [phone]
USA & Canada [phone]
Follow
Fixings
As a courtesy we have supplied a set of fixings for the system.
These screws and wall plugs are designed to be used in wood and brick walls. We understand our
systems may be used on a variety of materials; drywall, aluminim and steel stud, or lath and plaster.
To properly secure a system onto these or other types of
surfaces; appropriate fixings must be independently obtained.
Care & Maintenance
This pole can be cleaned using a soft
cloth and furniture polish.
End Passing
Dimension Z
Mid
Diameter Dimension Z
25mm (1”) 2mm (1/16”)
Exploded bracket
assembly
Please do not use any solvent or
chlorine based cleaners as this
will damage the finish.
!
Assess your own wall construction and source the appropriate screw type.
Please note that the enclosed fixings may not be suitable for all wall types.
!

Bracket Positioning & Fixing
Mark the position of the brackets. for longer poles a mid/passing
bracket is required. For bay window poles, passing brackets are
used in conjunction with passing curtain rings.
Drill holes & insert plugs.
Screw each bracket into position. Please note on the french
bracket, that the top fixing point is located in the insert.
Where brackets have coverplates, push them into place.
Ring Stop
To hold the curtain back
to the wall place a ring
between the bracket
and the set screw.
Fitting Rings and Pole
Slide the curtain rings on to the pole, allowing approximately one ring
for every 100mm (4”). On systems where passing rings are used
ensure the open side of the ring is facing the wall.
Keep aside two rings, one for the outside of each end of the bracket.
Push the pole on the brackets, and tighten the set screw. If the pole
is made of two connected lengths, the mid/passing bracket should
cover the join.
Joining the pole
Poles are supplied pre-cut to your specified
lengths, in some cases the pole may be made
in two or more parts, joined by a connector.
Push the joiner into the pole ends and push the
poles together. Tighten the set screws at the
back of the pole.
Passing Brackets
The pole snaps into the passing bracket. this operation should only be done
once, as repeated attempts can damage the finish.
Ensure that the pole is in the correct position first. Then gently pull the pole
down whilst holding the bracket up.
!