Artesyn MVME3100 User manual

MVME3100
Quick Start Guide
P/N:6806800M29B (May 2014)
Observe ESD-safe
measures
What’s in the box?
Configure the hardware
When installing or servicing the
module or accessories, strictly
observe the safety precautions in
the Safety Notes. Otherwise, per-
sonal injury or property damage
may occur.
• Use either a properly grounded ESD wrist
strap or make sure that you are working
in an ESD-safe environment.
• Connect your ESD wrist strap to the ESD
connector at the front or the rear of the
system.
Make sure you receive all items of your
shipment:
• MVME3100 board
• Other items that were ordered
• Printed Safety Notes
Prepare the installation
site
For information on the environmental and
power requirements, see the MVME3100
Installation and Use manual.
1
2
3
4
To produce the desired configuration and
ensure proper operation of the MVME3100,
you may need to carry out certain hardware
modifications before installing the module.
For more information, refer to MVME3100
Installation and Use.
Install the MVME3100
board
5
1. Remove the filler panel filling the
slot on the chassis.
2. Install the top and bottom edge of
the MVME3100 into the guides of
the chassis.
3. Ensure that the levers of the two
injector/ejectors are in the outward
position.
4. Slide the MVME3100 into the chas-
sis until resistance is felt.
5. Verify that the MVME3100 is prop-
erly positioned and secure it to the
chassis using the two screws located
adjacent to the injector/ejector
levers.
6. Connect the appropriate cables to
the MVME3100.

MVME3100-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
Finding more information
For more information on the product, see
the MVME3100 Installation and Use and
other related documentation.
Visit our Web site http://www.arte-
syn.com/computing. Use the Product
Search link to look for technical documen-
tation.
Technical Assistance
To request technical assistance, visit our
Web site http://www.artesyn.com.
6
When the MVME3100 is installed in a chas-
sis, connect the peripherals.
The following table lists the available con-
nectors on MVME3100.
Table 1: MVME3100 Connectors
Connector Function
J4 PMC expansion connector
J11, J12, J13,
J14
PCI mezzanine card (PMC) slot 1
connector
J21, J22, J23 PCI mezzanine card (PMC) slot 2
connector
J24 Boundary scan header
J25 COP header
J27 USB connector
J28 Front panel sATA connector
J29 Planar sATA connector
J30 Planar sATA power connector
J41B 10/100/1000Mb/s Ethernet con-
nector
J41A COM port connector
P1, P2 VME backplane connectors
J1A, J1B, J1C,
J1D
COM port connectors
J2A 10/100/1000Mb/s Ethernet con-
nector
J2B 10/100Mb/s Ethernet connector
J10 PIM power/ground
J14 PIM I/O
P2 VME backplane connector
Complete the installation
7
1. Verify that the board is installed and
the power/peripheral cables con-
nected are appropriate for your sys-
tem configuration.
2. Replace the chassis or system cover,
reconnect the system to the AC or
DC power source, and turn the
Connect the peripherals