Article FLORU User manual

Assembly Instructions
FLORU
Sideboard
VERSION 1.0

ASSEMBLY INSTRUCTIONS
Read these instructions carefully and keep for future
reference. Refer to parts inventory for guidance, and
ensure you have all pieces before starting.
When assembling, place all parts on a soft, clean, and flat
surface such as a carpet to prevent scratches.
If you’re having diculty, our friendly Customer Care
team is always here to help. Call us at 1.888.746.3455
during business hours, email [email protected] or chat
live at article.com.
Page 2 of 6
FLORU Sideboard
PARTS INVENTORY
ID DESCRIPTION QTY
LEG 2
IRON PLATE 2
ALLEN KEY 1
M6 ×20MM FLATHEAD BOLT 8
M6 ×20MM BOLT 12
LOCK WASHER 12
WASHER 12
HANDLE 4
M4 ×15MM SCREW 8
TIME # OF PEOPLE
1
DIFFICULTY
15 min
REQUIRED TOOL
ANTI-TIP
Installation Required

Page 3 of 6
1A
FLORU Sideboard
1B
×8
×12
Two people are needed
for is next step, careful
to turn table over. Place
the table top on a soft
protected surface.
!

Page 4 of 6
2
FLORU Sideboard
×8

Page 5 of 6
DOOR ADJUSTMENT INSTRUCTIONS
If the door is crooked, adjust hinge(s) up or down:
3A
During shipping, the doors of your cabinet may have
shifted slightly. This can easily be corrected by tightening
a few screws. Always start by adjusting the top hinge on
the aected door.
REQUIRED TOOL
FLORU Sideboard

Page 6 of 6
3B
3C
If the door needs adjustment forward or backward:
page 6 of 610780
Assembly Instruction
SENO Sideboard
If the door needs adjustment side to side:
page 6 of 610780
Assembly Instruction
SENO Sideboard
FLORU Sideboard

Serious or fatal crushing injuries can occur from furniture
tip-over. To help prevent tip-over:
• Install tip-over restraint provided.
• Do not set heavy objects on top of this product,
unless the product is specifically designed to
accomodate them.
• Never allow children to climb or hang on mirrors,
shelves, consoles, or cabinets with doors and/or
drawers.
Use of tip-over restraints may only reduce but not
eliminate, the risk of tip-over.
20 min
3
TIME
REQUIRED TOOL
# OF PEOPLE DIFFICULTY
PARTS INVENTORY
ID DESCRIPTION QTY
BRACKET 4
M4 ×20MM SCREW 4
M8 ×51MM PLUG 4
M6 ×70MM SCREW 4
STRAP 2
ANTI-TIP RESTRAINT INSTALLATION
Page 1 of 3
CABINET Anti-Tip Installation
WARNING!
Hardware (C/D) to attach brackets to wall is
designed for drywall. To attach this unit to another
type of wall, consult with your local hardware store.
REQUIRED TOOL
8MM / 5/16" DRILL BIT
VERSION 1.3
1010 Raymur Ave.
Vancouver, BC V6A 3T2

Page 2 of 3
12
3
Attach pair of brackets to top corners
of the back of the unit. Note there are
no existing pilot holes on the product.
Mark on wall where second pair
of brackets should be placed.
× 4
× 4× 4 × 4
× 2
CABINET Anti-Tip Installation
Drill holes in wall using
8mm / 5/16"drill bit.

Page 3 of 3
4A
4B
Align brackets on unit
with brackets on wall.
CABINET Anti-Tip Installation
Pull strap down until it snap-locks.
× 2 × 2