Aruba AP25 User manual

AP25 Flush Mount Sleeve
Installation Guide
0512257-01 | January 2022 1
Package Contents
Plastic AP25 flush mount sleeve (R9B36A)
AP25 Flush Mount Sleeve Installation Guide
Introduction
The AP25 flush mount sleeve lines up the exterior of the access point, offering a practical and aesthetic solution
for concealment and customization.
Installation
Installing the Sleeve onto the Access Point
1. Fit the bottom corners of the AP25 flush mount sleeve around the access point, then press the sleeve onto
the access point until it clicks into place. See Figure 1.
Figure 1 Attaching sleeve onto access point
Installing the Access Point (with Sleeve) to a Ceiling Rail
1. Hold the access point next to the ceiling rail with the mounting tabs of the mount bracket at approximately a
30-degree angle to the ceiling rail.
2. Pushing toward the ceiling rail, rotate the access point clockwise until the access point clicks into place on the
ceiling rail. See Figure 2.
You may want to install the wall/ceiling mount bracket prior to installing the AP25 flush mount sleeve.
AP25 Flush Mount Sleeve IG.fm Page 1 Wednesday, January 5, 2022 5:13 PM

2 AP25 Flush Mount Sleeve | Installation Guide
Figure 2 Installing the Access Point (with Sleeve) to a Ceiling Rail
Removing the Access Point (with Sleeve) from a Ceiling Rail
1. Turn the access point (with sleeve) by hand counter-clockwise until the mounting tabs of the mount kit
disengage from the ceiling rail. See Figure 3.
2. After the access point (with sleeve) is removed from the ceiling rail, pull the sleeve off from the access point
by hand.
Figure 3 Removing the Access Point (with Sleeve) from a Ceiling Rail
Installing the Access Point (with Sleeve) to a Wall
1. Install the mount bracket to the wall as per the installation instructions provided with the wall anchors.
2. Align the access point (with sleeve) with the mount bracket, placing the access point so that it’s mounting tabs
are at an angle of approximately 30 degrees to the mount bracket.
3. Pushing towards the wall, rotate the access point (with sleeve) clockwise until it clicks into place. See Figure 4.
AP25 Flush Mount Sleeve IG.fm Page 2 Wednesday, January 5, 2022 5:13 PM

AP25 Flush Mount Sleeve | Installation Guide 3
Figure 4 Installing the Access Point (with Sleeve) to a Wall
Removing the Access Point (with Sleeve) from a Wall
1. Turn the access point (with sleeve) by hand counter-clockwise until the mounting tabs of the access point
disengage from the mount bracket on the wall. See Figure 5.
2. After the access point (with sleeve) is removed from the wall, pull the sleeve off from the access point by
hand.
Figure 5 Removing the Access Point (with Sleeve) from a Wall
AP25 Flush Mount Sleeve IG.fm Page 3 Wednesday, January 5, 2022 5:13 PM