Operating instructions Ascoline 700, AEH 030, 050
ascobloc Gastro-Gerätebau GmbH 01156 Dresden, Grüner Weg 29 Germany
Tel.:
+49
351
4533-0
Fax
+49
351
4537-339
Email:
[email protected] AEH0x0.doc Stand: 19.11.2018 Subject to change without notice!
2
2 General information on the appliance
AEH 030 Work counter with electric baking and roasting oven 6508.100
AEH 050 Work counter with air-vented oven 6509.100
(Technical data sheet enclosed)
3 Details for the secure handling of the appliance
3.1 General Details
These are technical appliances which are exclusively made for industrial use and operation under
supervision.
The appliances are not intended to heat rooms or other materials, except those, which are normally used
for baking and roasting.
The appliance should only be operated in a sufficiently ventilated room.
Technical modifications of the appliance without a prior written authorisation by the manufacturer are not
allowed and result in a total loss of warranty. The product liability of the manufacturer invalidates
immediately.
These instructions must be announced to all employees concerned when they are trained in how to use
the appliance.
3.2 Safety instructions for handling, cleaning and repair
Some parts, like the oven door or the covering plate are, depending on the frying and roasting function,
very hot. Save yourself by only touching the appliance at the control elements and wear appropiate
clothing, which avoids the direct contact with your skin.
Operation and cleaning must be carried out by trained employees. Maintenance and repair must be
carried out by qualified personnel only.
The manufacturer is not responsible for damages caused by impoper installation or operation. In these
cases of damage the warranty becomes void.
When carrying out repair al poles of the appliance must be free of voltage (use cut-off device provided by
customer, e.g. fuse)
3.3 Shipping instructions
We advise to ship ascobloc-appliances only in their original packing in order to avoid unnecessary
damage or costs.
Check appliances for damage before unpacking and again before installation.
Do not raise or move the appliance using the top plate, the lower edges on the side or the door handles.
Instead please use the lower edges at the front or at the back.
3.4 Installation instructions
The appliance is wired up to the connection box. To ensure the safety of our products it is necessary that
every connection process is carried out by an expert. Please allow these experts to look at these
documents. The statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV etc.) as well as the
connection conditions of the local electricity supply company must be observed completely.
Before beginning the installation work, it should be checked that the mains voltage, mains type and the
current rating of the fuse match the values given on the type plates. An isolating device in the customer's
scope of supply that is effective on all poles must be provided, e.g. contactor fuses with at least 3 mm
contact gaps, so that the equipment is disconnected from the power supply during repair and installation
work. Connection to an equipotential bonding system is available (check effectiveness).
Do not bend, squash or damage cables (according to EN 60335-2-50) on any sharp edges. Lay the
cables in such a way that they cannot be brought into contact with hot parts. The connection cable
leading through the appliance must be fully sheathed from the connection point up to the entrance to the
terminal box. The appliance is intended for fixed connection; it is not permitted to connect the appliance
using plugs.
