Ashford KNITTERS LOOM STAND 70cm User manual

Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture, please contact the dealer you purchased it from. To
validate the guarantee, please go to www.ashford.co.nz/product-registration
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone [phone]
[e-mail] www.ashford.co.nz
INSTRUCTIONS
KNITTERS LOOM STAND 70cm (28ins)
KL7LS210813V2

Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone [phone]
[e-mail] www.ashford.co.nz
1. Attach the base rail (with the Ashford logo) to one side and one foot and secure with a washer and knob. Note
the metal bracket faces out and the tapered side fits snugly into the tapered rebate in the foot. Tighten the
knobs to make the joint tight.
2. Secure the top rail to the same side with a washer and knob.
3. Attached the other side and foot. Secure with a washer and knob.
4. Completely unthread the side knobs on the Knitters Loom. Partially thread the knobs back on. Slide the loom
onto the metal brackets keeping the washers between the loom and the brackets. Tilt the loom to a convenient
weaving angle. Lift the back of the loom to engage the 2 L blocks, check the reed support blocks are upright and
tighten the side knobs.
5. Included with the 70cm (28ins) stand are 2 support braces. They are optional accessories for the 30cm (12ins)
and 50cm (20ins) stands. Locate the support braces under the Knitters Loom front cross rail and then attach
them to the Loom Stand sides with bolts, washers & knobs.
6. Adjust the angle of the Knitters Loom to suit you. Lift the support braces up under the front cross rail and tighten
all knobs.
foot
side
bolt
top rail
metal brackets
washer and knob
washer and knob
washer and knob
washer and knob
bottom rail
support brace