ASROCK iBOX-280 User manual

Inside View
Front View
Rear View
iBOX-280
Quick Installation
Guide
M/B
HDD mounting bracket
Front Panel
Rear Panel
CPU Heatsink
SO-DIMM sockets
2 x USB 2.0 2 x COM Power LED
HDD LED
On-/o Switch
DC-IN 4 x USB 2.0 HDMI
Intel 82574L LAN VGA
Line-Out
Mic-In
Antenna PortAntenna Port
P/N: 15G06M013000AK V1.0
*15G06M013000AK*

1. Removing the Top Cover
2. Installing the SO-DIMM
3. Installing the Hard Drive
4. Installing a 2.5-inch Hard Drive
5. Replacing the Top Cover
Note
1. Remove the ten screws that secure the top cover.
2. Li up and remove the top cover.
* Please install the SO-DIMM module into the
DDR3_A2 for the rst priority.
2. Li up and remove the HDD mounting bracket.
1
2
1. Remove the four screws that secure the HDD
mounting bracket.
1
2
3
2
1
2
3
2
1
1. Replace the top cover, making sure the mark on
the top cover is aligned with the HDD mounting
bracket.
2. Install the ten screws that secure the top cover.
1
1. Place the HDD into the HDD mounting bracket.
2. Secure the hard drive into the place using the
four screws (two on each side).
3. Aach one end of the SATA 1 to 1 Power Cable
to the hard drive.
4. Secure the HDD mounting bracket to the chassis
using the four screws.
13
2
2
2
2
2
5. Aach the SATA data cable and power cable
to the motherboard.
SATAII_1SATA_PWR1
For more details on the hardware installation,
please refer to the User Manual in the support CD.
e terms HDMI™ and HDMI High-Denition
Multimedia Interface, and the HDMI logo are
trademarks or registered trademarks of HDMI
Licensing LLC in the United States and other
countries.