Astro Tool 620667 User manual

1 9-19-14 TI667-14-0
ASTRO TOOL CORP.
CONNECTOR ASSEMBLY TOOLING
HOW TO USE THE LARGE DEDICATED CRIMP TOOL
Catalog Number 620667
GENERAL
The 620667 is a cycle controlled hand crimping tool.
It is a fast, versatile, manually operated, octadent tool for
crimping circular pin and socket contacts.
This tool is configured for one specific wire size and
is set to .071”at the factory and locked in place. The
620667 also includes a locator that is permanently
attached. No operator adjustments are required.
For long life and optimum performance, this tool
should be kept clean and handled carefully, as any other
precision instrument.
OPERATION
Open and close the tool several times and observe the
precision cycle control ratchet mechanism. Note that the
tool may not be opened or closed without completing the
cycle.
TOOL GAGING
It will be necessary to verify the opening by using a
gage pin assembly. Gage, 620667-G, is available to
properly gage this hand tool. Close the tool completely
and insert the GO end of the gage assembly between the
indenters, as shown in figure #1.
Indenter
Gage Pin
Figure #1
The GO pin should slide freely between the indenter
tips.
Close the tool down completely and insert the NO
GO end of the gage assembly into the indenter opening
as shown in figure #1.
The NO GO pin must NOT go between the indenter
tips.
CAUTION:
DO NOT CRIMP GAGE
TOOL DAMAGE WILL RESULT.

2 9-11-03 TI548-93-2
TOOL SERVICE
Astro Tool's 620667 Crimp Tool is designed for long,
reliable service. If the tool becomes inoperative or does
not gage properly, it is suggested that you contact our
Customer Service Department for a Return Goods
Authorization number and return the tool to our factory.
Upon receipt of the tool, Astro will inspect and
overhaul each tool to put the tool back into acceptable
and efficient operating condition. Worn parts will be
replaced or repaired.
Service charges for tools not under warranty will be
advised upon request.
Parts that Astro deems to have been damaged due to
neglect, misuse or accident; and parts that have been
altered or repaired by persons other than Astro Tool
Corp. employees will be replaced subject to additional
charge for such parts.
ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,
CRIMP TOOLS AND CONNECTOR SERVICE KITS
ASTRO TOOL CORPORATION 21615 S.W. T-V HWY. BEAVERTON OREGON 97003
503-642-9853 FAX [phone]