ATG Electronics iBright HCL-FLT8N-0600E0-F1 User manual

Page 1 of 3
ATG Electronics® iBright™ Flat LED Panel
USER GUIDE
PART NUMBER
NOTE
Please read this entire manual to fully understand and safely use this product.
Specifications are subject to change without notice. Please visit www.atgelectronics.com for the most
recent user guide versions.
INCLUDED IN THIS BOX
ATG Electronics® iBright™ Flat LED Panel, 1 PCs
User Guide, 1 Set
UNPACKING
1) Unpack and carefully examine the product.
2) Report any damage and save all packing materials if any part(s) were damaged during shipping.
3) Do not attempt to use this apparatus if it is damaged.
INSTALLATION INSTRUCTIONS
1) CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
2) The product should be installed and operated by a qualified electrician or technician in accordance
with relevant local codes.
3) Risk of electric shock. Ensure that main power source is off when wiring or soldering the sections of
the product.
MAINTENANCE
1) Disconnect the product from the power supply prior to cleaning.
2) Use a dry or slightly moistened cloth for cleaning.
INSTALLATION CONSIDERATIONS
1) The product must be AT LEAST 0.2 m distant from any flammable materials.
2) The product must not be installed into ceilings or walls that contain heat-insulating materials.
HCL-FLT8N-0600E0-F1
HCL-FLT8N-0600A0-F1
HCL-FLT8N-0312E0-F1
HCL-FLT8N-0312A0-F1
HCL-FLT8N-0612E0-F1
HCL-FLT8N-0612A0-F1
ATG
Electronics Corp.
Light your world
Color your life!

Page 2 of 3
INSTALLATION STEPS
1. Built-in Installation:
1) Turn off main power before installation.
2) Remove the ceiling panel.
3) Connect the input and ground wires (bare end) of the driver box to the main power outlet.
4) Connect the Flat LED Panel to the corresponding connectors on the output wires of the driver box.
5) Fit the Flat LED Panel into the ceiling.
2. Suspended Installation:
Accessories for suspended installation are available at an extra charge.
1) Turn off the main power before installation.
2) Mount the driver base to the ceiling with screws.
3) Connect the input and ground wires (bare end) of the driver to the main power outlet.
4) Attach the round cover to the base with screws.
5) Clamp the connectors of suspended cables to the interfaces of the Flat LED Panel.
6) Connect the Flat LED Panel to the corresponding connectors on the output wires of the driver.
www.atgelectronics.com

Page 3 of 3
ATG Electronics® iBright™ LED Flat Troffer Specifications
iBright™2X2 Flat
iBright™1X4 Flat
iBright™2X4 Flat
Dimensions
For EU Market
595*595 mm
295*1195 mm
595*1195 mm
For US Market
603*603 mm
301*1212 mm
603*1212 mm
LED QTY
729
702
1458
Power Consumption
42W±2W
40W±2W
84W±4W
Input Voltage
100-277VAC 50/60 Hz
Beam Angle
150°
* For detailed specifications, please refer to the product catalog of iBright™ Flat LED Troffer.
628 Zhangyang Road, Suite 1-21B
Shanghai 200122, CHINA
www.atgelectronics.com
E-mail: [e-mail]
Phone: [phone]
Fax: [phone]
Ver6.1-120523
ATG
Electronics Corp.
Light your world
Color your life!