HostPower 3001
Line Interactive UPS
•Server UPS S3000. Potenza 3000 VA (1800W). Tecnologia Line Interactive ad onda sinusoidale con stabilizzazione di tensione. Filtri di protezione di linea
telefonica o LAN . Batterie tipo “long-life”. Autonomia 15 minuti al 50% del carico . Batterie “HotSwap” sostituibili dall’utente. Display LCD con stati di fun-
zionalità e parametri elettrici. Software di shutdown automatico e diagnostica del server per Windows 95/98/2000 Linux e UNIX..
Specifiche Tecniche
Power
•3000VA / 1800W
Input
•Voltage Single Phase; 220/230/240V selectable
by DIP Switch (±25% )
•HZ 50Hz/60Hz ±5%
Output
•Voltage(AC) Increase 15% (Input:-9% to
-25%); Decrease 15% (Input:+9% to +25%)
•Voltage(INV) Inverter mode:±3%
•Waveform(INV) Pure Sine-Wave with THD 3%
at linear load
•Hz(INV) Inverter mode: 50Hz or 60Hz ± 0.1Hz
Transfer
•Line/Battery Nearly Zero Transfer (<6ms typi-
cal)
Battery
•Half-load runtime 9 min
•Capacity 12V/9Ah
•Quantity 4
•Recharge Time 2-4 Hours to 90%
•Type Sealed Maintenance Free Lead Acid VRLA
Type
Protection
•Over/under Volt. Switch to Battery Output
whrn the Utility over regulation range
•Overload(AC/INV) >110% Buzzer continuosly
alarms and shuts down after 10 minutes
•Short Circuit(AC/INV) Input Fuse & Electronic
Circuit / Electronic Circuit
•Low Battery Two stages, no battery drain after
cut-off
•EMI/RFI Full time suppression
•Surge Protection Meet with IEEE 587 cat. A&B
Standard
•Modem/Network RJ11 / RJ45
•Energy Rating 960 Joules instantaneous
response
•Attenuation Better than 45dB @1Mhz for Nor-
mal/Common mode
•Noise Filtering EN50991-1
Connections
•Output 4*IEC(Battery Power Supply) +
1*Schuko
•Computer RS232(DB9) and USB
Display And Diagnostics
With LCD and LED Display
LCD Display
•Status: Normal, AC Input High, AC Input Low,
On Battery, Battery Low, Battery Bad, Over-
load, Fault, Phase error, Ground Fault
•Data: Utility Voltage, Ouput Voltage, Output
Hz, Load%, UPS Temperature, Battery Voltage,
Runtime Timer
LED Display
•Green=Normal, Amber=Warning, Red=Critical
•LCD shows detalis in respect to the lighting
indication of LED
Beeping Alarm
•Overload, Fault, High Temperature, Battery On,
Battery Low, Battery Bad, Over/Under Voltage,
Frequency Error
Advanced Mode
•Self-diagnostic; Direct Time-based readout of
battery remained runtime
Communication Port
•USB/DB9 port with TRUE RS232 serial signal
plus dry contact signals
Environmental Condition
•0-40°C; 0-95% Non Condensing Humidity
Safety Approval
•CE/UL
Dimension (W*H*D cm)
•17*24*47
Weight (N.W/ G.W) Kg
•26
Codice Ean
80269740062360
All rights registered
Microsoft and Windows are registered trademarks of Micro-
soft Corporation
All trade names and marks are registered trademarks of re-
spective companies
Specifications are subjected to change without prior notice.
No liability for technical errors and/or omissions.
