Atlas Scientific IoT pH meter User manual

Users guide
V 1.0

The IoT pH meter has been completely installed onto a Raspberry Pi and both
EZO ™circuits are set to I2C mode, but there's a very small amount of work that needs
to be done before you can take readings.
Step 1
Quick setup guide
Hardware assembly
1. Connect both probes to thier repsective BNC connectors
on the back of the case.
2. Locate the power supply, and plug
the micro USB end into the USB splitter.
4. Plug the power supply into an outlet, and press the on/off
button on the power supply cable.
3. Connect both ends of the USB splitter
into the two USB ports on the back of the case.
2Copyright © Atlas Scientific LLC

Step 2 Boot up
Once the IoT pH meter has been turned on, it will begin to boot up. This process may
take up to 1 minute. Once the boot up sequence is complete, you will be at the
Windows IoT core page.
If you want to connect a newtwork cable directly into the IoT pH Meter, there is a network
connection port located on the back. However, if you want to use Wi-Fi follow the steps
below.
To connect the IoT pH Meter to your Wi-Fi, press the gear ( ) button located at the
bottom left corner of the screen, then press Network & Wi -Fi.
From here, connect to the Wi-Fi network of your choice.
Step 3 Setup Network / Wi-Fi

Now that the IoT pH meter is connected to the interenet, it's time to adjust a few settings
from the back end via the Windows 10 IoT Core Dashboard, click HERE to download the
setup file.
Once you open the IoT Dashboard, you should see Atlas iot listed under My devices.
Click here and a web page will open and will ask you to log into the IoT pH Meter .
Step 4 Windows IoT Core Dashboard
double click
Username: administrator
password: atlas
4Copyright © Atlas Scientific LLC

You are now in the device portal (back end) of your IoT pH Meter. Under Device Settings
you can make adjustments to things like display orientation, resolution and time zones.
If you don't have any settings to adjust, move on to step 6.
Step 5 Adjust settings
If you make any changes the device must reboot before you can continue.
5Copyright © Atlas Scientific LLC

From the device portal (back end) of your IoT pH Meter, click on Apps >Apps manager.
Here you will see that Atlas iot will be displayed on a list of installed apps. Tick the startup
button, to begin running the IoT pH Meter software.
Step 6
Setup complete!
Startup