6
April 2005
Ticket Printer Ithaca®850
Ticket loading procedure
1. Make sure that there is power to the printer and
slide the printer mechanism assembly towards
open position, so that the assembly is unseated
from the outer slide chassis' racking retainer.
2. Remove any loaded tickets remaining from the old
ticket stack (see previous page).
3. Remove the tear off band from the new paper stack
and place the paper stack into the ticket box.
The printable (blank) side has to face down.
(even if otherwise stated on the paper itself).
The top of form mark has to be on the leading
edge of the ticket, facing upwards.
4. Insert the leading ticket into the printer mecha-
nism assembly's insertion guide area. When the
ticket is fed about 15 mm into the mechanism, the
printer automatically completes the feeding.
5. Slide the printer mechanism assembly back into
closed position, making sure that the assembly's
slide plungers snap into the racking retainers wi-
thin the outer slide chassis.
6. The printer is ready for printing.
Top of form mark
OPERATING
