AUDAC AWP06 Installation and operating instructions

PROFESSIONAL AUDIO EQUIPMENT
In-wall Ceiling Speaker AWP06
UserManual&InstallationGuide
CeilingSpeaker
AWP06
AUDAC

A U D A C P R O F E S S I O N A L A U D I O E Q U I P M E N T
User Manual & Installation Guide
AUDAC
http://www.audac.eu
[e-mail]

1
INTRODUCTION...............................................................................................................................................................................................................3
WARNING-CAUTION.......................................................................................................................................................................................................4
INSTALLATION ...............................................................................................................................................................................................................5
CONNECTIONS.................................................................................................................................................................................................................5
ADDITIONAL INFORMATION.......................................................................................................................................................................................6
TECHNICAL SPECIFICATIONS ..............................................................................................................................................................................6
Index

2
Introduction
With the AWP06 is you have purchased a state-of-the-art ceiling speaker. The speaker was
specially designed to provide high-quality sound in a variety of in- and outdoor
applications and damp locations. Its wide, smooth frequency response and high efficiency
ensure high-fidelity music reproduction and intelligible speech at very low distortion. The
housing is made of strong, white ABS material and is waterproof. The AWP06 can be used
in a 100V PA system with tapping for 6 W or 3 W or in low impedance systems 8 Ohm/6
W. The AWP06 ceiling speaker meets the IP65 standards.

3
Warning
Use only the correct amplifier output voltage and impedance, exceeding these limits
could cause fire or other failures.
Avoid explosions: do not use the speaker around gasoline, thinner or other
combustibles.
Only install the speaker in locations that can structurally support the weight of the
speaker. Not doing this may result in the speaker falling down.
Do not use any other method than specified to mount the speaker. If extreme force is
applied to the speaker, it could fall down.
Attach a safety wire to the speaker when it is mounted high above the ground. Failure
in doing so could cause the speaker to fall down for any reason.
Avoid mounting the speaker in locations exposed to constant vibrations. The
mounting points can be damaged by excessive vibration, potentially causing the
speaker to fall down.
Caution
Avoid electric shocks: switch off the amplifier power when connecting the speaker.
Avoid installing the speaker in locations exposed to solvents, acids, smoke and
heaters, as excessive exposure to these factors could result in speaker failure, fire or
electric shock.
Do not operate the speaker for an extended period of time at distorted sound. This
could cause (irreparable) damage to the speaker.
Do not stand or sit on, nor hang down from the speaker, as this may cause failure of
the speaker.

4
Installation
Make a hole with a diameter of 140 mm This is very easy when you use the carton
that is inside of the box.
Install the unit only in a ceiling made of strong material so that the mounting springs
don’t damage the ceiling. For weak ceiling panels you can use a wooden plank to the
ceiling in which you can make the mounting hole.
Connections
Cable
Be sure that you use the following polarities for your speaker cable, when using
several speakers in the same location:
Red: Negative or common
Black: Positive
The total rated input of all connected speakers may not exceed the amplifiers
output.

5
Additional information
Technical Specifications
RMS Power 6 W
Max Power 10 W
Impedance 8 Ohm
Line transformer power tappings 6 W / 1666 Ohm
3 W / 3333 Ohm
1,5 W / 6666 Ohm
Sound pressure 1W / 1m 87 dB
Sound pressure max W / 1m 95 dB
Frequency response -3 dB 100 Hz –15 kHz
IP Rating 65
Driver 4”
Dimensions ( H x Diam.) 130 x 140 mm
Built-in depth 130 x 140 mm
Cut-out measurement 125 mm
Weight 0,95 Kg
Colour White