Audio enhancement THE SAFE SYSTEM MS-1000 User instructions

Setting up the MS-1000
The MS-1000 requires that you download software in order to set the IP Address, Subnet
Mask and Default gateway. The software is “Device Discovery” and cab be downloaded from
here:
http://ftp1.digi.com/support/utilities/40002265_g.exe
STEP 1—Download and run the install program from your download directory
STEP 2—Before running the Device Discovery software connect the MS-1000 to the net-
work with a standard CAT 5 cable.
STEP 3—Start the program and you should see the following screen:
The software will poll the network and locate the MS-
1000 on the network. Click on the desireddevice if its
not already highlighted.
STEP 4 -Click on "Configure network settings"to
bring up the configure network settings screen.

STEP 5—Click on "manually configure network settings"
STEP 6
Enter this information based on
the IP Address you obtain from your
IT department
Default password is “audioe”

Firmware updates for the MS-1000
STEP 1- Place the MS-1000 on a network that allows access to the public internet.
That is -- The MS-1000 must have HTTP access to www.tac-comm.com
It will automatically connect,it just needs to have access.
STEP 2 - Press and continue to hold the “Enter” button while plugging the power sup-
ply into the back of the MS-1000.
Continue to hold the “Enter” button while
the flasher flashes and the beeper beeps
and until you see the LCD display
“Download Starting.” You can now
release the "Enter"button.
The LCD will display the download status
and will display “Download Complete” in
just a few moments. It will then beep and
flash and display “Initializing.”
The MS-1000 will start up in its normal
mode.
The firmware update process is now
complete.