Audio Visual Furniture PM-HDCB User manual

6mm Hex Key
(1)
M8 X20 M8 NUT
(4) (4)
Attach the bracket in the desired position and
location using the 4 nuts and bolts provided.
Hand tighten the nut till its snug.
Place codec to confirm cable clearance before
tightening completely.
HDCB Clamp
(1)
HDCB Bracket
(1)
Plastic Spacer
(2)
10-32 Nut
(2)
10-32 Washers
(2)
3mm Washers
(2)
AUDIO VISUAL FURNITURE INTERNATIONAL
288 Don Hillock Drive, Aurora, Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: [phone] Local: 905-751-1459
Note: If you cannot understand these instructions or are concerned about safety of the installation
Contact a qualified contractor or contact AVFI at 1-877-834-3876.
Confirm all hardware is included before you begin assembly.
Not all hardware supplied will be used depending on the manufacturer of your display/s.
PM-HDCB
Mounting Instructions
Thank you for purchasing AVFI's High Definition Codec Bracket.
This product was designed for mounting a single HD Codec
to AVFI PM-S-FL, PM-XFL-D & PM-XFL-S display stands or for
mounting on to/into a wooden or MDF cart or a wall.
Supplied Parts:
Supplied Hardware:
Page 1
of 2
Hardware Bag
(1)
rev 2.0
OR
The Lifesize codec only requires a single piece mount.
If Using Polycom or Tandberg Codec, assemble the two
pieces using the 10-32 nuts with washers.
You want the two pieces to adjust later, so don't tighten
the nuts.

Attaching Lifesize Codec
1.Remove existing stand.
Retain screw for next step.
Attaching Polycom HDX / Tandberg Codec
2. Using screw from step 1 and spacers.
Attach bracket to Codec as shown.
1.Remove existing stand.
Retain screws for next step.
2. Using screw from step 1 and
washers if required.
Attach bracket to Codec loosely.
Do not tighten till after next step.
3. Lower clamp into slots on
Polycom or gripping ring on
Tandberg. Tighten clamp with
3/8 wrench. Tighten screws
from step 2.
3/8 wrench
+ screwdriver
AUDIO VISUAL FURNITURE INTERNATIONAL
288 Don Hillock Drive, Aurora, Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: [phone] Local: 905-751-1459
Page 2
of 2