AudioBus DF2402 User manual

We present you our:
DF2402
FATIGUE
DETECTOR
[email protected] [phone] www.audiobus.com
1. Connect the terminal.
2. Put the magnetic base on the detector’s lower part.
3. Remove the adhesive protection and fix the device in the
correct position, without interfering in the driver’s view.
4. Connect the terminal and stare to the sensor lens untill
the indicative frontal LED becomes green, indicating a
correct face reading.
5. Sensor has to be installed in vertical position, do not
completely fix the adhesive untill a correct face reading.
6. To check the system’s correct working , frontal led has to
be unblinking or blinking when it detects the driver’s eyes
opened. Correct distance for an optimal reading is
600-900mm, seeking for the LED to be glowing as much
time as it’s possible.
7. The Green LED blinking is normal while the driver opens
the eyes, especially wearing glasses with mount.
8. If the green LED keeps glowing or blinkin when the driver
turns the head left or right, or moves up and down, means
the installation of the detector is even better.
9. Device installation must me inside a 20 degrees inclina-
tion range from the normal driver’s view position, and if it’s
istalled in front of him/her, it must be 15 degrees.
DF2402
INSTRUCTIONS FOR:
INSTALATION

DF2402
The DF2402 incorporates a system that, through a camera and
an software that analyzes driver’s gestures, acctions and moves,
detects when the driver starts to fell tired or sleepy and, therefore
he/her is not in conditions to drive.
System realices a tracing of various aspects of the driver’s face,
incluiding eye’s aperture degree, or facial gestures.
Also analyzes the driving patterns and reactions of the driver,
and combines it with speed and traffic, hour and blinker behavior.
If the system detects fatigue or tiring signs, it issues an audio-
visual signal to te driver, eviting accidents like departure leaving,
or crashing with another cars.
New Ways of Safe Driving
FATIGUE DETECTOR
SAFETY AND USE
[email protected] [phone] www.audiobus.com
SAFETY DRIVING SAFETY DRIVING
INSTRUCTIONS
CLEANING
Unplug the terminal from the electrical outlet before
cleaning. Normally a dry cloth is enough to clean it,
but you can also use a wet one, that doesn’t drop lints
or a suede. If it’s necessary use a dry cloth with alcohol
in order to clean accumulated dust. Do not use liquid
cleaners or spray, and keep the product surface clean.
SOURCES OF HEAT
You mustn’t install near to sources which release heat
as heaters, stoves or another devices.
INSTALATION
In order to protect the terminal, avoid its installation or
its use in places exposed to direct light, rain or dust.
VENTILATION
The terminal casing slits are there with the aim of
ventilate, avoiding overheating and guaranteeing a
reiable functioning. Do not use another casing unless it
provides enough ventilation.
WATER
Do not use this terminal near to the water or wet
considered areas.
OVERCHARGING
Do not overcharge electrical outletss or extension
cords. It can lead to fires and electric shocks.
POWER SUPPLY UNPLUG
Power supply wire is the principal device for the
unplugging of the supply in order to interrup all the
terminals tension.
POWER SUPPLIES
Use the terminal only with the supply type indicated in
the label.
REPARAIRING
Do not try to repair this terminal by your own. If you
open or take off the casing, you could be exposed to
dangerous tension or another risks. Every repairing has
to be made by qualified staff.
SAFETY CHECKING
Once the maintenance operations have been done,
check if the terminal is in te proper conditions for a
correct functioning.