Audiosystem SW 11 ACTIVE User manual

IMPORTANT: Your proof of purchase is evidence of warranty claim for repair or replacement. Keep your proof
of purchase, manual and original packaging.
IMPORTANT: Before installation of your spare-wheel-subwoofer, we recommend to read the owner‘s manual
carefully and to follow the instructions regarding connection and fitting exactly.
Audio System Germany accepts no liability for hearing loss, bodily injury or property
damage as a result of use or misuse of our products. We recommend installing the equipment by an
authorized service center or dealer. A professional fitting and connection is the requirement for further
warranty and perfect sound.
ATTENTION: Pay attention to advices and instructions of the car manufacturer.
ATTENTION: Use of sound components can impair your ability to hear neccessary traffic sounds and may
constitute a hazard while driving your automobile.
SW 11 ACTIVE - SW 11 PASSIVE
10 - 16 V
150 W
> 92 dB
50 - 150 Hz
20 Hz
0° / 180°
35 Hz ~ 150 Hz (+/-1 dB)
< 0,3%
0 bis +12 dB
25A
0,1 V ~ 10 V (+/- 5%)
360(D) x 135(H) mm
2x 175 W
35 Hz ~ 150 Hz (+/-1 dB)
2x 2 Ohm
360(D) x 135(H) mm
equipment SW 11 ACTIVE
technical data SW 11 active
Technical data SW 11 passive
Congratulation on your purchase of your new SW-Series Subwoofers.
SW
SW
SW
- 27,5cm Active-Spare-Wheel-Woofer with extremely heavy housing
- PRS (Phantom-Resistor-Simulation) impedance simulation
- Extremely wide input sensitivity from 0,1 to 10 V
- Multi-Way-Protection-Circuitry: overheating, overcurrent, short circuitry & DC protection
- High-Power-Input (normally OEM radio) with automatically „Turn-On“
- Cable-High-Level-Input or Cinch-Input
- Included RTC SW wired remote for Gain, Bass Boost, Low-Pass-Filter and Phase
4

blue
SW

SW
The SW 11 ACTIVE has RCA LOW-LEVEL inputs to connect it to the pre-output connection of the headunit
using a RCA cable. When using RCA connections you also have to connect the remote input (blue) to remote or
antenna out of headunit.
If your car radio doesn‘t have RCA outputs (normally OEM radios) you can connect the speaker outputs directly to
the HIGH-LEVEL inputs of the SW 11 Active. The amplifier will turn on automatically with remote wire.
Fig. 1: Connection variant Low-Level
Fig. 2: Connection variant High-Level Fig. 3: Connection RTC SW
All settings can be adjusted by
using the RTC SW wired
remote.
You can adjust the gain, bass
boost, low-pass-filter and phase
to match the car and your pre-
ferred sound setup.
SW COnnection SW 11 PASSIVE
AMPLIFIER
It is possible to connect the SW 11 PASSIVE in different configurations. By this you can use the subwoofer
as 2x 2 Ohm (figure), 1x 4 Ohm (row) or 1x 1 Ohm (parallel) subwoofer.

SW