Audiovox Rampage AVW100 User manual

HIGH PERFORMANCE
SUBWOOFERS
MODELS AVW100 and AVW120
OWNERS MANUAL

128-6684
2 of 4
Congratulations on your purchase of the Rampage High Performance
Subwoofer. The
Rampage Subwoofers are designed to provide you with high
quality Bass reproduction required to make your car audio system perform to
its full potential.
RAMPAGE Subwoofer Features
lSingle 4-Ohm voice coil for maximum flexibility and performance
lDouble stacked magnet
lChrome plated stamped steel basket
l2-Inch Hi-Temp Kapton voice coil structure
SUBWOOFER PARAMETERS
AVW100 AVW120
Nominal Power Rating 200 Wrms 250 Wrms
Peak Power Rating 400 W 500 W
Double Stacked Magnet40 Oz 50 Oz
FrequencyResponse 40 Hz-1kHz 40 Hz-1kHz
ResonantFrequency 55 Hz ± 20% 55 Hz ± 20%
Woofer Size 10" 12"
Nominal Impedance 4 Ohms 4 Ohms
Mounting Depth 5.25" 6.0"
WARNING: High-powered car audio systems may produce sound
pressurelevels that exceed the threshold atwhichhearing
loss may result. They may also impair a driver’s ability to
hear traffic sounds or emergency vehicles. Use common
sense and practice safe listening habits when listening to
your audio system.
2

INSTALLATION RECOMMENDATIONS
To realize the utmost in sound reproduction from your subwoofer(s), follow these
installation recommendations:
Use a quality large gauge wire to connect your subwoofer to the
amplifier
Use a subwoofer crossover to remove unwanted higher frequencies
Position the enclosure in the rear of the vehicle with the subwoofer
facing rearward to improve bass response and avoid cancellation
of audio frequencies
ENCLOSURE CONSTRUCTION RECOMMENDATIONS
To enhance subwoofer performance, the following general recommendations should
be addressed when constructing the speaker enclosure:
Use 3/4" MDF for your construction material
Glue all joint seams
Screw or nail all joints tight
Brace all walls
DESIGNING AND BUILDING YOUR SPEAKER ENCLOSURE
The following parameters are offered to assist you in designing your own enclosure.
There are many computer software programs available on the market that, along with
this information, will allow you to construct the type of enclosure that best suits your
needs.
To obtain the best possible results, we suggest you use our recommended enclosure
designs and have an automotive sound professional build your enclosure.
3

4
 
         
       
Parameters AVW100 AVW120
Fo (Hz) 29.33 26.98
Revc (Ohms) 3.2 3.2
Levc at 1kHz (mH) 2.07 2.89
Qms 5.28 4.73
Qes 0.39 0.35
Qts 0.36 0.33
Vas (Ltrs) 72.59 117.72
Spl @ 1W/1M (dB) 88.58 90.07
X-Max Linear 12 14
pk-pk (mm)
AVW100 AVW120
SEALED
Minimum sealed (Cu. Ft) 0.5 0.75
Maximum sealed (Cu. Ft) 1.0 1.5
PORTED
Vented (Cu. Ft) 1.5 1.75
Vented to (Hz) 36 36
Port Diameter (“) 3 4
Port Length (“) 8 12
Number of Ports 1 1
SQUARE PORT INFO
Port Area (Sq/In) 7 12
Port Length (") 8 12
© 2003 Audiovox Electronics Corporation, Hauppauge, NY 11788 128-6684
Recommended Enclosure Volumes