Austech Surveillance & IT SoloSafe User manual

Charging your device:
The first time you use the device please ensure you charge it fully for 2-3 hours.
Using the USB charger or docking station to charge your device:
•Place the device in the docking station
•Connect the Micro USB side of the cable to the docking station port and connect the other
end of the cable to the supplied AC adaptor
•Plug the adaptor into mains power
Switching the device on and off:
•To turn the device on press and hold the ON/OFF button as shown in the above diagram for
1 second, all LED’s will flash rapidly.
•To turn the device off press and hold on the ON/OFF button and the SOS button together for
1 second until the LED’S are off.
**Note: It is important when first turning on the unit, to complete this function outdoors to allow
the unit to obtain a satellite fix**
NSN SOLOSAFE USER GUIDE

POWER STATUS LED:
LED
Blue ON (solid)
Blue Blinking Quickly
Blue off or Blinking
Slowly
State
The device is charging
Battery power is lower
than 15%
Device has been fully
charged or is not
charging
GSM LED: GREEN
LED
Light shows a
single flash
rapidly every 3
seconds
Light shows a
double flash
rapidly every 3
seconds
Light shows a
slow flash
every 3
seconds
Light solid not
flashing
State
The device is
connected to the
3G network
The device is
registered to the
3G network
The device is
connected to
the 3G network
No 3G connection
GPS LED: BLUE
LED
Light shows a single
flash rapidly every 3
seconds
Light shows a slow
flash every 3 seconds
(1 second on 3
seconds off)
Blue off (when device
is not charging)
State
The device has GPS
positioning fix
The device has no GPS
fix
The GPS chip is
sleeping
Activating on SOS Alarm:
Press and hold the silver SOS button located on the front of the device as marked in the function
diagram for 3 seconds until the device vibrates. The green LED light will commence flashing rapidly
to confirm the activation. ARM Security Monitoring centre will receive this event and commence
actioning the instructions you have provided ARM.
In the event you need to contact your monitoring centre we have provided ARM securities details
below.
For general enquiries please call or email Austech Surveillance and IT
ARM SECURITY:
[phone]
WEB: WWW.ARMSECURITY.COM.AU
EMAIL: [e-mail]
AUSTECH SURVEILLANCE & IT
1300 737 225
WEB: AUSTECHSURVEILLANCE.COM.AU
EMAIL: SALES@AUSTECHSURVEILLANCE .COM.AU