. ee e fur re e f e sensor/transmitter e
uig ii e rerier figure .
. ee f f e fr er e.
. ie er e i i e er figure .
. See ei ie Pairing ranitter to eceier
. ote e er ge e i i ue ire e f
reeier fr iue e riggere.
•e ERA s e rrae a ERA receiver ci
rrai isrcis seis i isrcis are
icle i is aal
•sl e receivers ser aal r re eails seciicais r
seis
•e ERA is ere a alalie aer icle
• ERAs a e rrae a ERA receiver eres
lii e er receivers rrae e ERA
•s recee cse a iere el r eac rrae
receiver s ca eerie ic rasier riere e receiver
•e e rasier aer is l i case e receiver eerae
e s ice i a r
•acae ces R sesrrasier lae sivel
scres li receiver is ser ie
Pair ranitter to eceier
(Always test unit prior to installation)
e rier r i e included receiver, the ERA-RXPG, as well as the
reeier. Bi rgrig fr e uer ir
e rier i reeier ee e fr e rier
iru e reeier e riggere.
ire
Setu Ste or Setting Senorranitter
sall a aer icle ee e seci ile aer
sallai ote reassele e case il rrai is
clee
Pair e sesrrasier e receiver ee
seci ile Pair ranitter to eceier Once you have
e se seis e rasier a e ase as eee
lease see seci ile ance Senor Setting
•iesis ices
•erai eerare
•erai reec
-DSRXPG Alarm Kit
Owner’s Manual
Introduction
e ERA is a r rae R sesr caile i all ERA
receivers e e ciai ea i are eece e
sesr ill rasi a ireless rai sial e receiver
is ser aal is r e ERAR ic icles e r
rivea sesr e li receiver
elul ote
ERA-DSTX Sensor Specifications:
•Power source: 9V alkaline battery
•eeci rae l ei i
•ireless rae
ire
ire
Battery Installation:
ire 5
1. Plugin the receiver (figure 5) into a standard wall outlet.
2. Hold down the "mode" button on the receiver until you hear a short tone
sound. A red LED will appear in the strobe lens of the receiver. This
denotes programming mode.
3. By default, the receiver is set to play the "ding-dong" sound. To change
the melody, press the "volume" button to scroll through the available
sounds. Once you hear the melody want, stop pressing the button.
4. Next wave your hand over the "sensor cell" or press the "test" button on
the transmitter/sensor (see figure 4).
5. You should hear a quick chime sound denoting successful pairing of the
sensor to the receiver. If this is the only sensor/transmitter you are
programming, go to the next step. To pair an additional transmitter,
repeat steps 3 & 4.
6. To exit programming mode, hold down the "mode" button (figure 5)
until you hear a short tone sound (approximately 3 seconds).
