AUSTRALIAN MONITOR IS600 User manual

The Australian Monitor Installation Series IS600 & IS1200 are 2 RU stereo power amplifiers.
> 2RU
> dual channel 4 or 8 ohm operation
> 2 x dual speed fans
> Power, Signal, Clip & protect LED indication
> Balanced XLR/6.35mm TRS inputs
> Speakon/Binding post outputs
> 3 stage input sensitivity switch
> Stereo/parallel switch
> Ground lift switch
> IS600 2 x 300 @4 ohms
> IS1200 2 x 600 watts @ 4 ohms
> Short circuit protection.
> Overload protection.
> Soft Start.
> Thermal protection
2 RU Stereo Power Amplifiers
At a Glance...
It features:
A More Thorough Examination...
The IS series continues the Australian Monitor tradition of delivering an amplifier
packed with clever features at a contractor friendly price.
The IS600 delivers 300 watts per channel @ 4 ohms & the IS1200 delivers 600 watts per channel @ 4 ohms.
Designed for permanent installations where high quality audio reproduction is required on a small budget,
the IS series deliver the sound quality & features contractors require. The IS series continues the Australian
Monitor tradition of delivering an amplifier packed with clever features at a contractor friendly price.
AMIS IS600

Engineered and Distributed by AUDIO TELEX COMMUNICATIONS PTY LTD (ABN 78 001 345 482), 149 Beaconsfield Street, Silverwater, Sydney, NSW, 2128 Australia
NSW Tel: [phone] Fax: [phone] VIC Tel: [phone] Fax: [phone] QLD Tel: [phone] Fax: [phone] WA Tel: [phone] Fax: [phone]
SA Tel: [phone] Fax: [phone] NZ Tel: [phone] Fax: [phone] International Enquiries - [email protected] www.australianmonitor.com.au
2 RU Stereo Power Amplifiers
IS600 & IS1200
Architecture & Engineering Specifications
The amplifier shall be 2 RU dual channel with low impedance output of 300 watt per
channel at 4 ohms/600 watt per channel @ 4 ohms. The amplifier will have two dual
speed fans, short circuit, Overload, soft start & thermal protection. Have switch
operable ground lift, stereo/parallel operation, input gain sensitivity.
Inputs shall be balanced XLR or 6.35mm TRS type & speaker outputs
shall be Speakon or binding post type.
The amplifier shall be the IS600/IS1200.
IS600 Specifications
Output @ 8 ohms 2 x 200 watts
Output @ 4 ohms 2 x 300 watts
Frequency Response <10Hz - >50kHz (-3dB)
THD <0.03% @ 1kHz
Crosstalk 60dB
Damping Factor 250 into 8 ohms/ 125 into 4 ohms
Input Impedance 20Kohm
Signal/noise ratio >99dB 20Hz-20kHz
Weight 20KG
Shipping Dimensions (wxdxh) 635mm x 590mm x 160mm
IS1200 Specifications
Output @ 8 ohms 2 x 400 watts
Output @ 4 ohms 2 x 600 watts
Frequency Response <10Hz - >50kHz (-3dB)
THD <0.03% @ 1kHz
Crosstalk 60dB
Damping Factor 250 into 8 ohms/ 125 into 4 ohms
Input Impedance 20Kohm
Signal/noise ratio >105dB 20Hz-20kHz
Weight 25KG
Shipping Dimensions (wxdxh) 635mm x 590mm x 160mm