Autel Robotics Dragonfish Pro User manual

Charger Quick Start Guide
Dragonfish Pro

Using the charger
Registered Trademark
Shenzhen Autel Robotics Aviation Technology
Co., Ltd. (hereinafter referred to as "Autel
Robotics") has been registered in China, the
United States and in several overseas
countries. EVOIITM, DragonfishTM AutelVoyag-
erTM, StarpointTM and Autel Robotics® are the
registered trademarks of Autel Robotics. The
names of the products and companies
mentioned in this manual are trademarks
respectively held by Autel Robotics.
Copyright
Without explicit written consent of Autel
Robotics, no part of this manual may be copied
or forwarded in any form or by any means
(whether electronic, mechanical, photocopy,
recording or other means).
Disclaimer
Thank you for purchasing the Autel Robotics
Dragonfish Pro Charger. Please follow the
guidelines in this manual to ensure safe use of
the charger. Only adults 18 years and older are
permitted to use this product. Keep out of reach
of children when not in use.
If you fail to abide by these safety instructions,
Autel Robotics will not provide warranty service
for damages to the product during use, nor will it
be liable for any product damage or loss (wheth-
er direct or indirect, legal, special, accidental or
economical (including but not limited to loss of
profit)) during use. Do not use incompatible parts
or use any method that does not comply with the
official instructions of Autel Robotics to modify
this product.
The safety guidelines outlined in this manual will
show you the steps and methods to safely utilize
the charger. Please ensure that, when using this
product, you do not endanger the personal and
property safety of you and others.
This manual will be updated from time to time. To
download the latest version, please visit
https://auteldrones.com/pages/dragonfish-down-
loads.
Introduction
The output voltage and current of the charger are
52.8V and 14A, respectively. This charger is a
smart charger and is capable of charging two
aircraft batteries and a ground station at the
same time. When charging two batteries at the
same time, please make sure both batteries have
about the same battery level to have an
optimized battery charging.
Warning
• To ensure proper heat dissipation, do not
cover the charger when charging.
• Always place the charger in a stable and
safe location.
•During charging, try to avoid touching the
metal casing of the charger to prevent high
temperature burns.
Follow the steps below to charge the aircraft
battery and ground station:
1. Please connect one end of the charger to a
100~240V AC power source, and connect the
other end to the aircraft battery, as shown in the
figure below.
2. When the aircraft battery is charging, the LED
light will be flashing.
3. When the battery is fully charged, the LED
indicator on the aircraft battery will be off and
disconnect the charger from the battery.

Specifications
120 minutes
DF15_CHARGER
41°F to 113°F (5°C to 45°C)
100-240V (50-60Hz 10A MAX)
*
Model Name
Operating temperature
Input voltage
Output Power
* Time required to fully
charge (single battery)
Main output: 1/2/ 52.8V 14A
Total output power: 740W
The time required for a full charge is based on data captured under a laboratory environment and room
temperature. The actual full charge time may vary in real-world environments and surroundings.

©2021-2022 Autel Robotics Co., Ltd. All Rights Reserved