Autohaus AHWL-10W Manual

10W PORTABLE LED WORK LIGHT
DIRECTIONS FOR USE
A H W L-10 W
PARTS IDENTIFICATION
A: Padded Carry Handle
B: Portable tube
C: Luminous panel
D: Lamp body xing frame
E: Screw Knob
F: Stand
ASSEMBLY
1. Slide the stand (F) into the worklight bracket
(D). Align the holes in the bracket and the
stand. Insert and tighten angle adjustment
screw knob (E).
2. To alter the angle of the worklight, simply
loosen the angle adjustment screw knob(E),
pivot the worklight until the desired angle is
achieved and re-tighten knob (E). Check the
worklight is secure and that the stand is stable
and has a rm footing.
3. Ensure the cable does not catch on any sharp
object and that the mains plug connection is
adequately protected against rain or moisture.
4. Your worklight is now ready for use.
A
B
D
E
F
C

INSTRUCTIONS FOR USE
1. Ensure that the worklight is always kept
upright and used on a at surface
2. Do not operate the worklight if the glass lens
is broken
3. Do not operate if there is any damage to the
unit
4. Do not look directly into the light source
5. Keep a minimum distance of 1 metre from the
light source
6. This unit can become hot whilst in operation;
do not touch the unit until it has had time to
cool down.
7. If damaged contact a service agent for repair
CARE AND MAINTENANCE
• Clean unit with a damp cloth to avoid dirt and
dust build up
• Ensure that the unit is never stored for
prolonged periods with a fully discharged
battery
• Keep away from direct sunlight
• Ensure that unit is protected from temperature
extremes or high humidity at all times,
including during operation.
DISPOSAL
Dispose of this product in accordance with local
body regulations. If unsure contact the local
council for advice.
Marketed by:
Autohaus NZ
71 Adams Drive, Pukekohe,
Auckland, New Zealand
Ph: 0800 473 743
www.autohausnz.com
SPECIFICATIONS
Type JM01J-10W
LUMEN 800LM
Rated voltage: 220-240V~ 50Hz IP65