Omega 94228 User manual

1
Operating Instructions
Cordless Rechargeable
28 LED Work Light
Model 94228
• 28 super bright LEDs
• 360 ratcheting hook
• Hi-tech light focusing reector/lens
• Rechargeable Lithium-ion battery
• 5-6 hour of continous use
• AC wall charger and DC 12V adapter included
• High impact, shatter proof design
• Overcharge and over-discharge protection
94228-M0_042011

2
This is the safety alert symbol. It is used to alert you to potential hazards. Obey all safety messages that follow
this symbol to avoid possible personal injury and property damage.
Save these instructions. For your safety, read understand, and follow the information provided before attempting
to use. Use and repair of this product may require special skills and knowledge. Instructions and safety information
shall be conveyed in the operator’s language before use of this product is authorized. If any doubt exists as to the
safe and proper use of this light, remove from service immediately.
Inspect before each use. Do not use if broken or damaged parts are noted. Immediately remove from service
when the light operates abnormally or appears damaged in any way. Ensure switch is in the “OFF” position before
charging. Product must be charged BEFORE USE.
CONTENTS:
One (1) 28 LED Work Light
One (1) 110-120V AC charging adapter
One (1) 12V DC vehicle charging adapter
!
!CAUTION
• Work Light is not waterproof and is not intended for use in showers, saunas or potentially wet locations.
• Avoid charging at temperatures above 104°F (40°C) or below 32°F (0°C).
• Do not use charging cords other than those provided by manufacturer.
• The DC charging cord lighter plug may become very warm when in use. Unplug from receptacle with caution,
keep the cord and lighter plug away from ammable materials.
This device utilizes a rechargeable Lithium-ion battery that can rupture, ignite and cause serious injury if
misused. Observe the following safety rules:
• Do not place battery/device in re or high temperature.
• Do not tamper with battery wiring.
• Do not puncture or damage battery. Do not use a battery that appears damaged.
• Do not immerse or expose battery to water.
• Do not alter or modify the battery.
• Do not attempt charging the battery in any manner other than that prescribed in this manual.
• Do not dispose of the battery in re or water.
• Failure to heed these markings may result in personal injury and/or property damage
!WARNING
! DANGER
! CAUTION
! WARNING
NOTICE
Safety Symbols
Indicates situation which, if not avoided,
will result in death or serious injury
Indicates situation which, if not avoided,
could result in death or serious injury
Indicates situation which, if not avoided,
may result in minor or moderate injury
Indicates situation which, if not avoided,
may result in damage to property

3
OPERATING INSTRUCTIONS
1. Charge the Work Light for 3-4 hours prior to initial use. Battery is only 50% charged at time of shipment.
Note: The Li-ion battery will accept a partial charge, but a full charge will require 3 - 4 hours.
2. To charge, turn Work Light off and plug either the AC household current adapter or DC vehicle adapter into Work
Light handle. Refer to illustration for location of the handle charging receptacle.
3. Plug adapter into appropriate 110-120V AC or 12V DC receptacle.
Note: It is normal for battery to become warm during charging. Battery should cool to room temperature after
disconnecting from electrical source. Discontinue charging if battery becomes excessively warm.
4. For best results and prolonged battery life, fully charge battery overnight for the rst three charge cycles and allow
it to completely discharge before recharging.
Note: Battery will self-discharge during storage. Higher temperatures (68°F\20°C) reduce battery storage life.
BATTERY CARE AND HANDLING
DO NOT disassemble your Work Light or attempt to remove the battery.
DO NOT puncture or otherwise damage the battery. If battery becomes damaged, properly dispose of Work Light.
DO NOT use any charging means other than those provided. The supplied AC to DC 12V 500mA charging adapter
and 12V DC vehicle charging cord are made specically to charge the built in sealed Nickel-Metal Hydride
battery.
DO fully charge the Work Light every 3-4 months whether used or not.
DO operate Work Light at ambient temperatures between 32 °F (0°C) and 122°F (50°C).
DO store Work Light at ambient temperatures between -4 °F (-20°C) and 140°F (60°C).
DO apply a partial charge to the Work Light if storing for a prolonged period.
DO charge battery at ambient temperatures between 32 °F (0°C) and 104°F (40°C).
Although the battery in your Work Light does not contain the dangerous heavy metals present in other types of
batteries, it should be disposed of properly. Disposal and recycling regulations vary - always observe your applicable
regulations. Contact the Rechargeable Battery Recycling Corporation (www.rbrc.org) or your local recycling
organization for further instruction.
On/Off Switch
Charging
Receptacle

4
1 YEAR LIMITED WARRANTY
For a period of one (1) year from date of purchase, SFA Companies will repair or replace, at its option,
without charge, any of its products which fails due to a defect in material or workmanship under normal usage. This
limited warranty is a consumer's exclusive remedy.
Performance of any obligation under this warranty may be obtained by returning the warranted product, freight
prepaid, to SFA Companies Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
Except where such limitations and exclusions are specically prohibited by applicable law, (1) THE
CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE
PRODUCTS AS DESCRIBED ABOVE. (2) SFA Companies SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL
OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER. (3) ANY IMPLIED WARRANTIES, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, SHALL BE LIMITED TO NINETY DAYS, OTHERWISE THE REPAIR, REPLACEMENT OR REFUND AS
PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER,
AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. (4) ANY MODIFICATION,
ALTERATION, ABUSE, UNAUTHORIZED SERVICE OR ORNAMENTAL DESIGN VOIDS THIS WARRANTY AND
IS NOT COVERED BY THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not
apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specic legal rights, and you may also
have other rights, which vary from state to state.
SFA Companies
10939 N. Pomona Ave. Kansas City, MO 64153
1-888-332-6419
[email protected]
MAINTENANCE
Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth and a mild soap if needed. Be sure not to
get electrical plug socket wet. DO NOT submerge any part of your Work Light in any solution to clean it. DO NOT
use solvents such as gasoline, turpentine, brake cleaner, etc. to clean Work Light.
Clean lens with household window cleaner, then wipe with soft, clean, dry cloth. Do not use in wet conditions. Dry
thoroughly before use. Store Work Light in dry, clean area only. Avoid high humidity and temperature.