AutoMeter AC-15 User manual

�
4
1
AC-15 Infrared Printer
Instruction Manual
For use with all Auto Meter Hand-Held Testers
This infrared printer allows test results to be printed at a distance up to
20 feet.
2650-1261-00
Rev. A
Test Equipment
Auto Meter Products Inc.
413 West Elm Street
Sycamore, IL 60178
Toll Free (866) 883-TEST (8378)
Fax [phone]
www.autometer.com
Phone [phone]

2
3
1.
1.
2.
2.
4.
4.
1. Plug the AC adapter
in and the Red LED
will light up.
2. Point the I/R receiver
that is on the front
panel, in the direction
of the vehicle or tester
being used.
3.
4. When the test is complete,
point the tester in the general
direction of the AC-15 Infrared
Printer. Press the print key on
the tester panel. The test
number and results indicated
on the tester LCD will print
out on the AC-15 printer.
5. To feed the paper manually,
Press the LF button to start
feeding the paper. Press the
LF button again to stop
feeding. Printer will
automatically stop
the feed in
10 seconds. You are
now ready to print.
OPERATION
The AC-15 Infrared Printer can be
operated from up to 20 ft. away.
PAPER INSTALLATION
CONGRATULATIONS!
You have chosen the AC-15 printer designed for use with the all Auto Meter
handheld testers. If you should have any questions about this product please
refer to the contact information on the back cover of this manual.
Note: The AC Adapter needs to be plugged in to load and advance paper.
1. Remove the paper compartment cover by sliding it towards the
back of the printer
2. Make sure the paper has a clean cut. Press the LF button. Feed the paper
into the slot as illustrated (see g. 3). Make sure the paper loops under the
roller & not over. Once the paper is fed squarely, press the LF button again
to stop the paper from feeding any further.
3. Feed the paper up through paper cutting slot
on the paper compartment cover. Replace
the paper compartment cover by aligning
the tabs and sliding the cover forward.
You are now ready to print.
PAPER HOLDER ASSEMBLY
Standard Thermal Paper Roll - (58 mm)
Available from any ofce supply
AC Adapter
(120 VAC Output 9 VDC)
Printer Dimensions
6 1/4” W 4 1/8” D 1 3/4” H
1. Right and left arm snap into center base.
2. Clip hooks onto the notch located on the
backside of printer with cover off. Then
swing bracket down and snap the
brackets in place. (g. 2)
3. Replace cover.
4. Insert Rod.
Perform the test using
your Auto Meter
hand-held tester.
NOTE:
If the infrared receiver on
the printer is exposed to
direct sunlight, the printer
may not function properly.
Turn the printer so that the
infrared receiver is not exposed
to direct sunlight, and reduce
the printing distance from
hand held testers.
(g. 2)
(g. 3)