AutoMotionShade 4270P User manual

414: R-1:09/18
Effective Date: Sep 19, 2018
Quick Reference Guide # 13
Pairing 2nd Gen Remotes with 2nd Gen Ignition-Lock motor 4270P, using 216P (External
Receiver RF Module):
Optional wired switch
1 foot length
Red/Green/Blue
BLK/WHT
4270P Motor
216P
External
Receiver
Box
Power (12V)
Power (12V)
4270P Motor
with new generation RF option
BLK/WHT
Green/ Blue/ Red wires
(Red goes to ignition wire of vehicle)
Note 1: This external module only works with 2ndgeneration of AMS Remotes (203P, 204P, 213P)
Note 2: Using the wired switch is optional. If you use this option, you can control both from wired switch and remotes.
216P
Receiver Module
+12VDC
0VDC
To Optional wired Switch
To Motor

414: R-1:09/18
Effective Date: Sep 19, 2018
Pairing 216P with 2nd generation remotes
1. Connect the output plug of the External Receiver Module to Motor, and input plug to the wires coming from the
optional wired dash switch that controls the shade. The red wire connects to ignition wire of vehicle.
2. Ensure the Module is connected to a 12V DC power supply (white wire to ground, black wire to 12V power). A green
light on the Module should now be lit.
3. On the remote, first choose the channel you want to program by pressing the button of that channel.
4. On the External Receiver Module, press and hold the pushbutton until the color of the light inside changes to red,
then release it and within 2 seconds, press and hold the pair button on the back of remote for few seconds (until SET
appears on display if your remote has a display), then release it and immediately press the stop button on front of
remote.
Note 1- To clear or unpair a channel on the remote, press and hold the pair button on back of remote for few seconds
(until SET appears on display if your remote has a display), then press “down” button on front of remote.
Note 2- To reverse direction, press and hold the pair button on back of remote for few seconds (until SET appears on
display if your remote has a display), then press “up” button on front of remote.
To dash switch
To 12V Power