AUTOTERM Qstart Setup guide

1
Autoterm Qstart connection and
set up manual

2
Autoterm Qstart (assy.AT0006) modem comes with a
connector and connection wires.
Also the modem can be equipped with an GPS antenna.
To connect Qstart modem to your heater there is two
possibilities:
First: Connecting Qstart modem to control panel
If you have control panel with additional wire (it can be in
Yellow or Pink color) like in picture below

3
You need to connect wires from modem like this:
Red wire connects to battery (+)
Yellow wire connects to ignition or battery (+)
Black wire connects to battery (-)
Purple wire connects with control panel additional wire
(yellow or pink)

4
Second: Connecting Qstart modem to heater trough relay
If you don`t have additional wire to heater, then you need to
connect modem to heater like this scheme
Attention!!! You need to get 4 pin relay for this connection
type like in picture
Red wire connects to battery (+)
Black wire connects to battery (-)
Purple wire connects to "85" pin of relay

5
From heater (Modem wires) goes two wires brown and white
Those wires connects to "30" and "87" pins of relay
One more wire from battery (+) Connects to "86" pin of relay

6
Setting up Qstart Modem
If one of these connection methods are done you need to insert sim
card with no numbers in memory and without pin code
Factory settings for this modem is for connection with control panel
Remember if you connect this modem with relay, first you need to
send one more message:
SET P99 0
To start heater in preset mode just send these messages:
ON 30 (the heater will switch on for 30 min)
ON 60 (the heater will switch on for 60 min)
ON 120 (the heater will switch on for 120 min)
To turn off heater send:
OFF
For modems that are connected with relay you can start and stop
heater for unlimited time with this messages:
To start heater:
SET P30 1
To stop heater:
SET P30 0
Before turning on the heater in a no-time limit of work, make sure
that in the tank enough fuel and the heater will not harm the property
or the health of

7
Status indication LED
If you have additional GPS antenna you can get GPS data
with this command: