AV TOOL AVT-6041 User manual

AVT-6041
HDMI 4x1 Switcher
Instruction Manual

2

3
Table of Contents
1.0 Introduction 4
2.0 Specifications 6
3.0 Checking Package Contents 6
4.0 Connecting the Hardware 6
5.0 Operating The Unit 7
6.0 Troubleshooting 8
7.0 Limited Warranty 8
8.0 Regulatory Compliance 9
9.0 Contact Information 10

4
1.0 INTRODUCTION
Thanks for purchasing this product from the AV Toolbox Division of TV One. The
AVT-6041 HDMI 4x1 Switcher allows selection of any of 4 inputs for display on
an HDMI compliant display device. This version 1.3 HDMI device supports all
standard High Definition Television formats, PC formats from 640x480 through
1920x1200 as well as embedded HD-Audio, including Dolby® TrueHD and DTS-
HD. This is but one of our complete range of video and audio products.
1.1 Liability Statement
Every effort has been made to ensure that this product is free of errors. TV One
cannot be held liable for the use of this hardware or any direct or indirect
consequential damages arising from its use. It is the responsibility of the user of
the hardware to check that it is suitable for his/her requirements and that it is
installed correctly. All rights reserved. No parts of this manual may be
reproduced or transmitted by any form or means electronic or mechanical,
including photocopying, recording or by any information storage or retrieval
system without the written consent of the publisher.
TV One reserves the right to revise any of its hardware and software following its
policy to modify and/or improve its products where necessary or desirable. This
statement does not affect the legal rights of the user in any way.
All third party trademarks and copyrights are recognised. The TV One logo, AV
Toolbox logo, TV One-task and CORIO are the registered Trademarks of TV
One. All other trademarks are the property of their respective holders.
1.2 Features
HDMI 1.3, HDCP 1.1 and DVI 1.0 Compliant.
Allows switching of 4 inputs.
Supports 30/36 bit Color Depth Display.
Supports High Resolution PC Video Inputs (640x480 thru 1920x1200).
Supports embedded Audio including Dolby® Digital TrueHD and DTS-HD.
Signal Enhancement feature enables longer cable runs.
Remote Control is a standard feature.
Simple installation and operation.

5
1.3 Getting the Best Results
There are many factors affecting the quality of results when switching HDMI type
signals. Some basic precautions will ensure the best possible performance from
your AVT-6041 4x1 HDMI Switcher.
Output display device – The quality of the output signal will depend
largely upon the type and quality of the HDMI display device used.
For instance, some video projectors just look better than others.
Distance between the switcher, the sources and the display – This
plays a major role in the final result. Long distances are possible, but
special measures should be taken in order to avoid cable losses.
These include using high quality cables. Line amplifiers may also be
necessary for the longest runs.
Input/Output connection cables – Low quality cables are susceptible
to interference. They degrade signal quality due to poor matching and
can cause elevated noise levels. Cables should be of the best quality.
Interference from nearby electrical devices – These can have an
adverse effect on signal quality. For example, an older computer
monitor often emits very high electromagnetic fields that can interfere
with the performance of video equipment in its proximity.

6
2.0 SPECIFICATIONS
Input Format HDMI Version 1.3
Input Signal Types HDMI plus PC Video and DVI with optional adapters
Freq. Bandwidth 2.25Gbps (Single Link)
Output Format HDMI V1.3.
Output Signal Types HDMI V1.3 High Definition Multimedia Interface
Input Connector 4x Type A HDMI Female
Output Connectors 1x Type A HDMI Female
Device Control Via Front Panel Controls
Input Selection Via Front Panel Controls or Included Remote Control
Weight 0.55lbs (250g)
Dimensions–HxWxD 1.3”x8.1”x4.3” (32x206x111mm)
Power Source 100~240VAC to 5VDC/1A Adapter
3.0 CHECKING PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make certain
the following items are contained in the shipping carton:
1x AVT-6041 4x1 HDMI Switcher
1x 100~240VAC to 5VDC Power Adapter
1x User Manual
Note: Please retain the original packing material should the need ever arise to
return the unit. If you find any items are missing, contact your reseller or TV One
immediately. Have the Model Number, Serial Number and Invoice available for
reference when you call.
4.0 CONNECTING THE HARDWARE
The first step is to connect the HDMI Video Sources to the inputs of the AVT-
6041 switcher, connect its output to a HDMI Compliant monitor and lastly
connect the AC to DC Power Adapter. The drawings below show the locations of
the input, outputs, power switch and power connector.

7
4.1 Connecting the Inputs to the AVT-6041
You can connect any HDMI compliant device’s output to any of the AVT-6041’s
inputs. Make certain that the HDMI cable is securely plugged into the source
device as well as the AVT-6041. Always use a high quality cable, as short a
length as possible, for best results.
4.2 Connecting the AVT-6041 to a Display
Using a high quality HDMI cable, connect the output of the AVT-6041 to an HDMI
compliant display device. Use the shortest cable run possible.
4.3 Connecting Power to the AVT-6041
The AVT-6041 is shipped with a Power Adapter to convert 100~240VAC@50-
60Hz to 5VDC. Connect the DC Output Cable from the Power Adapter to the
back of the unit and then plug the Power Adapter into an AC Receptacle. You
will be able to turn the AVT-6041 via either the front panel power switch or the
power switch on the remote control.
5.0 OPERATING THE AVT-6041
The AVT-6041 4x1 HDMI Switcher can be operated via the front panel controls. If
the cable run length is excessive and the quality of the display is less than
optimum, you can press the Enhance switch on the front panel which will turn on
a low noise amplifier within the switcher and light an LED indicating that the
amplifier is in use. Provided there is enough signal for the amplifier to recover the
HDMI bitstream, you will be able to use inputs and a display located farther apart
than is normally possible. Another front panel control is the input select switch.
This switch is pressed to select the desired input. Each time the switch is
pressed, the next input in sequence (from left to right) is selected. LED displays
indicate which input is active. Finally, there is an On/Off Power Switch and an
indicator LED that shows when the unit is turned on.
5.1 Operation of the AVT-6041 via Remote Control
Operation of the AVT-6041 is possible via an included
Infrared Remote Control. Selection of Enhance mode
is not possible from the IR Remote however the unit
can be turned on and off and the inputs can be
selected simply by pressing the appropriate button on
the remote. Note:When you unpack the AVT-6041,
you may have to remove an insulator from the battery
compartment of the remote in order for the remote to
receive power. The battery compartment slides out
from the bottom of the unit.

8
6.0 TROUBLESHOOTING
In the event of problems, first make certain that the input and output cables are
no more than 50 feet long (for signals to 1080i resolution) and are of the highest
possible quality. Next, make certain that the Switcher is receiving power.
If all is well in these areas, remember that HDMI devices communicate with one
another so the source devices and destination device must be fully HDMI
capable. In addition, HDCP encryption requires additional processing which also
is dependent on the equipment you have connected to the sources and
destination device. If you experience problems using the AVT-6041 HDMI
Switcher, you should attempt to determine what is wrong by attaching each of the
source devices – one at a time – directly to the destination device using the same
cables you are using with the expanded system. This is a way of determining if
the problem is due to bad cables or a problem with the other devices. If you are
unable to obtain a signal using this simplified path, suspect the cables, the
source device(s) or the destination device.
After trying the above suggestions should the problem still persist, contact your
dealer for additional suggestions before contacting TV One. Should the dealer’s
technical personnel be unable to assist you, contact TV One via our support
website: http://tvone.crmdesk.com. Create a technical support request on the
site and our support team will respond within a short period of time.
7.0 LIMITED WARRANTY
LIMITED WARRANTY – With the exceptions noted in the next paragraph, AV
Toolbox warrants the original purchaser that the equipment it manufactures or
sells will be free from defects in materials and workmanship for a period of one
year from the date of purchase. Should this product, in AV Toolbox’s opinion,
prove defective within this warranty period, AV Toolbox, at its option, will repair or
replace this product without charge. Any defective parts replaced become the
property of AV Toolbox. This warranty does not apply to those products which
have been damaged due to accident, unauthorized alterations, improper repair,
modifications, inadequate maintenance and care, or use in any manner for which
the product was not originally intended.
Items integrated into AV Toolbox products that are made by other manufacturers,
notably computer hard drives and liquid crystal display panels, are limited to the
term of the warranty offered by the respective manufacturers. Such specific
warranties are available upon request to AV Toolbox. If repairs are necessary
under this warranty policy, the original purchaser must obtain a Return
Authorization Number from AV Toolbox and return the product to a location
designated by AV Toolbox, freight prepaid. After repairs are complete, the
product will be returned, freight prepaid.

9
LIMITATIONS - All products sold are "as is" and the above Limited Warranty is
in lieu of all other warranties for this product, expressed or implied, and is strictly
limited to one year from the date of purchase. AV Toolbox assumes no liability to
distributors, resellers or end-users or any third parties for any loss of use,
revenue or profit.
AV Toolbox makes no other representation of warranty as to fitness for the
purpose or merchantability or otherwise in respect of any of the products sold.
The liability of AV Toolbox with respect to any defective products will be limited to
the repair or replacement of such products. In no event shall AV Toolbox be
responsible or liable for any damage arising from the use of such defective
products whether such damages be direct, indirect, consequential or otherwise,
and whether such damages are incurred by the reseller, end-user or any third
party.
8.0 REGULATORY COMPLIANCE
The AVT-6041 has been tested for compliance with appropriate FCC and CE
rules and regulations. The Power Adaptor/Supplies have been tested for
compliance with appropriate UL, CUL, CE, PSE, GS Rules, Regulations and/or
Guidelines. These Products and Power Adapters areRoHS Compliant.
9.0 CONTACT INFORMATION
Should you have questions or require assistance with this product in areas not
covered by this manual, please contact TV One at the appropriate location.

10
AV Toolbox USA
2791 Circleport Drive
Erlanger, KY 41018
USA
Tel [phone]
Tel [phone]
Fax [phone]
[email protected]
www.avtoolbox.com
AV Toolbox Europe
Continental Approach
Westwood Industrial Estate
Margate, Kent CT9 4JG, UK
Tel [phone]
Fax [phone]
[email protected]
www.avtoolbox.com
AV Toolbox Latin America
6991 NW 82nd Avenue #8
Miami, FL 33166
USA
Tel [phone]
Fax [phone]
[email protected]
www.tvonela.com
AV Toolbox Mercosur
Av. Diaz Velez 3965 #PB
(1200) Capital Federal
Buenos Aires, Argentina
Tel [phone]
Fax [phone]
[email protected]
www.tvonela.com
AV Toolbox Asia
16F-4, No.75, Sec.1
Hsin Tai Wu Rd., Hsichih
Taipei Hsien 22101
Taiwan R.O.C.
Tel [phone]
Fax [phone]
[email protected]
www.tvoneasia.com
AV Toolbox China
Room 1007, Golden Peach Building
No. 1900 Shangcheng Road
Pudong, Shanghai
China 200120
Tel [phone]
Fax [phone]
[email protected]
www.tvoneasia.com
End of Manual