AVE DUBHE E700 User manual

DUBHE E700 Half fuselage Installation Instructions

First, you need to change the installation position of the tail brace and remove the fixing screws of the tail
brace.
Install the tail brace to the mounting position of the inner panel, and don't forget to tighten the screws of
the tail brace mounting pipe clamp.

Remove this screw and the corresponding screw on the other side and take out the outer side panel
mounting post.

Remove components such as wake box and pulley.
Loosen the screws of the wake box fixing ring and remove the M3*3 top
Insert the tail shell (it may be necessary to adjust the size of the reserved hole in the tail shell according to
the size of the tail servo you are using)

Use the M3*45 screws that come with the tail housing to fix the tail housing, and install M3 spacers on
both sides.

Insert a screwdriver through this hole to adjust the locking screw of the wake box fixing ring, first loosen
the fixing ring.
使用半圆头 M3*6 内六角螺丝固定
Use semi-round head M3*6 socket head cap screws to fix

On this side, fix the vertical tail with M3*8 hex socket head screws (original vertical tail and fishbone
vertical tail can be installed)
Adjust the installation angle of the wake box and finally tighten the locking screw of the wake box fixing
ring.
The mounting post of the outer panel can be inserted obliquely. Pull the outer panel out slightly and then
straighten the post.

Fix it here with the original screw

Turn the body upside down to see the inner plate support column
Adjust the position and insert the screw to fix it.

After the tail shell is installed, the head cover can be directly installed. Adjust the combination
relationship between the head cover and the tail shell by adjusting the up and down position of the rear
head cover mounting column.