AVERATEC N1030EA1E-1 User manual

TM
N1000 Series User’s Guide

i
PrefacePreface
Regulations Information
FCC-B Radio Frequency Interference
Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures :
✓Reorient or relocate the receiving antenna.
✓Increase the separation between the equipment and receiver.
✓Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
✓Consult the dealer or an experienced radio TV technician for help.
NOTE
✓The changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
✓Shield interface cables and AC power cord, if any must be used in order to
comply with the emission limits.

ii
PrefacePreface
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions :
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.

iii
PrefacePreface
Safety Guideline for Using Lithium
Battery
(Danish) ADVARSEL! Lithiumbatteri --- Eksplosionsfare ved fejlagtig
håndtering.
Udskiftning må kun ske med batteri af same fabrikat og type. Levé det
brugte batteri tilbage til leverandøren.
(Deutsch) VORSICHT: Explosionsgefahr bei unsachgemäßem Austausch
der Batterie. Ersatz nur durch denselben oder einen vom Hersteller
empfohlenen gleich-wertigen Typ. Entsorgung gebrauchter Batterien
nach Angaben des Herstellers.
(English) CAUTION: Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type recommended by the
equipment manufacturer. Discard used batteries according to
manufacturers instructions.
(Finnish) VAROITUS: Paristo voi räjähtää, jos se on virheellisesti
asennettu.
Vaihda paristo ainoastaan valmistajan suosittelemaan tyyppiin. Hävitä
käytetty paristo valmistajan ohjeiden mukaisesti.
(French) ATTENTION: II y a danger dex;losion sil y a remplacement
incorrect de la batterie. Remplacer uniquement avec une batterie du
meme type ou dun type équivalent recommandé par le constructeur.
Mettre au rebut les batteries usages conformément aux instructions du
fabricant.

iv
PrefacePreface
(Norwegian) ADVARSEL: Eksplosjonsfare ved feilaktig skifte av batteri.
Benytt same batteritype eller en tilsvarende type anbefalt av
apparatfabrikanten.
Brukte batterier kasseres I henhold til fabrikantens instruksjoner.
(Swedish) VARNING: Explosionsfara vid felaktigt batteribyte. Använd
samma batterityp eller en ekvivalent typ som rekommenderas av
apparattillverkaren. Kassera använt batteri enligt fabrikantens
instruction.

v
PrefacePreface
Macrovision Notice
This product incorporates copyright protection technology that is protected
by U.S. patents and other intellectual property rights. Use of this copyright
protection technology must be authorized by Macrovision, and is intended
for home and other limited viewing uses only unless otherwise authorized by
Macrovision. Reverse engineering or disassembly is prohibited.
Safety Instructions
1. Read the safety instructions carefully and thoroughly.
2. Save this User Guide for possible use later.
3. Keep this equipment away from humidity and high temperature.
4. Lay this equipment on a stable surface before setting it up.
5. The openings on the enclosure are used for air convection and to prevent
the equipment from overheating. Do not cover the openings.
6. Make sure that the power voltage is within its safety range and has been
adjusted properly to the value of 100~240V before connecting the
equipment to the power inlet.
7. Place the power cord in a way that people are unlikely to step on it. Do
not place anything on the power cord.
8. Always unplug the power cord before inserting any add-on card or module.
9. All cautions and warnings on the equipment should be noted.
10. If any of the following situations arises, get the equipment checked by a
service personnel:
✓The power cord or plug is damaged.
✓Liquid has penetrated into the equipment.

vi
Preface Preface
✓The equipment has been exposed to moisture.
✓The equipment has not worked well or you can not get it work
according to Users Manual.
✓The equipment was dropped and damaged.
✓The equipment has obvious signs of breakage.
11. Never pour any liquid into the opening that could damage the
equipment or cause an electrical shock.
12. Do not leave the equipment in an unconditioned environment with a
storage temperature of 60°C (140°F) or above, which may damage the
equipment.
13. To prevent explosion caused by improper battery replacement, use the
same or equivalent type of battery recommended by the manufacturer
only.

vii
PrefacePreface
WEEE Statement

viii
Preface

ix
Introductions