AVIRON A Series User manual

STRONG SERIES ROWER
User Manual
www.avironactive.com
QUICK ADJUST RESISTANCE REMOTE｜Type A

Part List
1
Type A
ROUND HEAD SCREW M2x16MM*4
HANDLEBAR CYLINDER *1
CONTROLLER COVER - BOTTOM *1
CONTROLLER COVER - TOP *1
A B C D
A
B
C
D
Please note that the Handlebar Type A has a vertical
line on the center part of the handlebar.

Type A｜Step 1 - Secure the belt
2
In order to ensure stability and safety, it is crucial to secure the belt properly. Start by
extending the belt to its full length, then fold it in half to create a loop. Tie a knot in
the loop, and attach it to the handlebar holder. This will provide some slack to the
handlebar and prevent the belt from being drawn into the rower. This step is extre-
mely important.

Type A｜Step 2 - Remove the cap
Tools:
3
(Optional)
To remove the cap at the end of the handlebar, you will need a flat head screwdriver.
Slowly use the screwdriver to loosen the cap by working your way around the circum-
ference of the end of the handlebar. Once the cap is removed, grasp the center and
push away from yourself while twisting. This will cause the foam grip to come out of
the handlebar. You only need to remove one end of the handlebar.

Type A｜Step 3 - Pry apart holder
4
To separate the holder, you may need to apply some force as it is typically glued to-
gether. If you end up causing some damage to the holder, don't worry as the part is
not necessary

Type A｜Step 4 - Insert the cylinder in the loop
B
Parts:
5
B
Insert the cylinder through the loop in the belt. The belt wraps around the cylinder.

Type A｜Step 5 - Slide the cylinder through the handlebar
6

Type A｜Step 6 - Attach the ring, foam and the end cap
7
To assemble the ring, foam grip, and cap, you may need to use some soapy water on
the handlebar and inside the foam grip to make it easier to slide into place. If necess-
ary, wiggle the foam grip until it is securely in place. While you can use glue to secure
the cap, it should stay in place without it.

Type A｜Step 7 - Ensure the top of the belt is smooth prior
to attaching the remote
8

Type A｜Step 8 - Snap in the top and the bottom resistance
remote on the belt
9
C
D
C
Parts:
D

Type A｜Step 9 - Secure the resistance remote by using the
four screws provided
Parts: Tools:
10
A
A

Type A｜Complete
11
Please remove the safety slip prior to rowing.

12
Battery Replacement
+
-
CR2032
To replace the battery in the remote, you may need to gently remove the battery
holder. Replace the battery with a CR2032 type and carefully insert the holder back
into the remote.

13
Tip 1: Make sure you adjust the resistance in the finish
position

14
Tip 2: Make sure the remote is directly aligned with the
screen
You may need to tip the screen up or down depending on your height

Tip 3: Keep the remote straight
15