Axema Codelock A04 User manual

Axema Access Control AB | Box 90215 | 120 23 Stockholm, Sweden | [phone] | i[email protected] | www.axema.se
Codelock A04
A04 is a robust, stand alone code lock for indoor and outdoor use.
Manual
Updated 04/11/2021

Connection
Connector Function
1-2 Power supply 10-40VDC or 8-35VAC
3-4 Relay output
5-6 Not used
7-8 Timer input
Closure between terminals 7 and 8 means that
code 3
(CODE 3) is not working.
9-10 Exit button
Programming
To start the programming mode
After power-up, the programming mode starts automatically when the enclosure is closed. The pro-
gramming mode can then be activated by one of the following options:
lWithin 45 seconds after a valid access (with code or exit button) unlock, open and close the
enclosure.
lWith six-digit programming code.
In programming mode CODE 1 , CODE 2 , CODE 3 and OPEN TIME flashes under the cor-
responding function buttons.
Determine programming code
1. Enter programming mode
2. Press A20.
3. Enter a six digit programming code twice. A valid entry is confirmed by a beep.
4. Exit programming mode by pressing B or wait for 30 seconds.
Add new code or change code
1. Enter programming mode
2. Press the function key for the code to be changed or added.
3. Enter the desired four-digit code.
4. Exit programming mode by pressing B or wait for 30 seconds.
2 (4) ManualA04

Delete code
1. Enter programming mode
2. Press the function key for the code to be deleted.
3. Exit programming mode by pressing B or wait for 30 seconds.
Change unlock time
1. Enter programming mode
2. Press the function key OPEN TIME .
3. Enter the desired unlock time (01-99 seconds).
4. Exit programming mode by pressing B or wait for 30 seconds.
Set relay function (NO / NC)
1. Enter programming mode
2. Enter one of the following:
lEnter A090 for NC relay function.
lEnter A091 for NO relay function (Managed).
3. Exit programming mode by pressing B or wait for 30 seconds.
Blocking after invalid code
Three incorrect attempts (four digits) block the code lock.
Reset takes place automatically after 1 minute or by entering a valid code twice.
Factory reset
1. Enter programming mode
2. Enter A 00199200.
Factory settings
l7 seconds unlocking time
lNo codes
lNO relay function (Normally open)
3 (4) ManualA04

Technical data and performance
Attribute A04
Tamper detection No
Power supply 10-40 VDC/8-35 VAC
Maximum relay load 10-30 VDC
IP rating IP55
IP rating IK08
Temperature range (C) -30° to +55C°
Number of codes 3
4 (4) ManualA04