Axent PRIMUS Manual

PRIMUS
INSTALLATION INSTRUCTIONS
&
USER MANUAL

Thank You for Choosing
Thank you for selecting an AXENT Switzerland product. To ensure proper installation, please review these instruction carefully before use. Carefully
unpack and examine the intelligent toilet before installation. For any questions, we may be contacted at 800-769-4857. Thank you again for choosing
AXENT
Before You Begin
Caution!
Risk of personal injury or product damage
Handle with care. Vitreous china can break or chip if handled carelessly.
ALL INSTALLATION PROCEDURES SHOULD COMPLY WITH
APPLICABLE LOCAL PLUMBING AND BUILDING CODES.
INSTALLATION BY A PROFESSIONAL LICENSED PLUMBER OR
CONTRACTOR IS HIGHLY RECOMMENDED.

2
SAFETY SYMBOLS
The following warning signs warn you of dangerous situations and their severity:
DANGER! High Risk, Lethal Hazards, Severe Injuries
WARNING! Medium Risk, Severe Injuries
CAUTION! Low Risk, Minor Injuries
NOTE! Damage to Property
NORMAL USAGE
This product is meant for indoors usage only. AXENT undertakes no liability for abnormal usage.
SAFETY INSTRUCIONS
READ ALL INSTRUCTIONS BEFORE USING
SAVE THESE INSTRUCTIONS
Information for the user
Children or persons with limited physical/mental capabilities may require
supervision or proper instructions/guidance prior to or during use.
Ensure that children cannot play with intelligent toilet.
Repairs must only be carried out by a person with the necessary
expertise
Do not carry out modifications, tamper with, install additional equipment, or
attempt to repair the intelligent toilet.
Improperly performed repairs can lead to accidents, injuries, or damage to
the product.
Avoid malfunctions and damage to the product as a result of
improper use
If toilet is moved from a cold location to a warm location, condensation
may form. Leave the unit switched off for a few hours.
Do not install the toilet in rooms where the temperature will be less than 4
°C ( 39 °F ).
Do not place open flames, candles, cigarettes, or similar objects on or by
the toilet.
Do not reuse old hoses or water lines. Please use new water lines when
installing.
Do not install the toilet next to items that would potentially expose the toilet
to a large amount of water.
Do not climb on or stand on the product.
Do not place any heavy objects on the lid.
Do not open or close the lid or seat with force.
Do not drop or insert any object into any openings or hoses.
TECHNICAL SUPPORT
For any questions or any assistance with this product, please contact your dealer or call us at
1-800-769-4857
[e-mail]
www.axentbath.us

3
SCOPE OF DELIVERY
Standard delivery contents
Main Body
PRIMUS with HIWAVE
INSTALLATION INSTRUCTIONS
&
USER MANUAL
Installation Instructions
& User Manual
12" Flange Adhesive
Inlet Hose and Filter
(Filter Adapter Requires 1/2" Pipe Thread Connection.)
Bowl Plug/ Magnet Tool Bowl Mounting Hardware
The below parts are not included with the toilet. Please prepare before installation.
Floor Mount Bolts Wax Ring

4
3
2
6
5
4
PRIMUS
1
/
12
Compression
4
” -
6
”
7 - 11
3 4
/
3 4
/
12
”
“
“
“
Please verify these dimensions before beginning installation. These dimensions may vary in some locations.
1
1/2" Nominal Pipe Thread (NPT)
(Some 7/16" & 1/2" Slip-joint
valve stops utilize 1/2" NPT. Verify
mating connection with the
included filter adapter first before
installation)

5
9
87
PRIMUS

6
2
PRIMUS

7
OPERATION AND MAINTENANCE
MANUAL FLUSH
The manual flush button is on the left side as you stand facing the toilet. Hold for 1 full second to flush.
SURFACE CLEANING
This product has been designed and manufactured with great care and attention to detail. If you follow a few simple cleaning instructions you will be able
to enjoy its comfort, quality and beauty for many years to come.
CLEANING INSTRUCTIONS SEAT, LID AND BACK COVER
Use a mild soap solution to clean the seat and please take care that the seat and hinges are not left damp. Dry off any residual water or cleaning agents
with a soft cloth. Avoid contact of the seat and hinges with abrasive, corrosive or chlorine-based cleaners, as these may cause damage or lead to flash
rust. When cleaning the bowl, make sure that the seat and cover are kept in an upright position until all cleaning agent has been flushed away.
CLEANING INSTRUCTIONS CERAMIC
Under no circumstances should you use harsh or abrasive cleaning substances such as abrasive cream cleansers, scouring powder or drain cleaner on
your ceramic surfaces. Also avoid using steam cleaners and hard, abrasive sponges.
The use of acidic cleaners with a pH value between 1 and 4 is highly recommended. Cleaners with a pH value in the neutral range (5 to 8) are not always
suitable. We strongly advise against using either weak or strong alkaline cleaners, i.e. substances with pH values from 9 to 12.
CLEANING THE INTAKE FILTER
2
COIN The intake filter may be detached and cleaned with soap and water as shown on the left.
When the water flow is less than normal, please clean the filter. Assure that the angle valve is shut off during
cleaning.
To reassemble, please put the filter back in reversed sequence after cleaning it.

8
TROUBLESHOOTING
FREQUENTLY ASKED QUESTIONS
IN CASE OF MINOR MALFUNCTIONS, PLEASE REFER TO THE FOLLOWING TABLE. IF THE BELOW SOLUTIONS DO NOT RESOLVE
THE ISSUE, PLEASE CONTACT CUSTOMER SUPPORT FOR FURTHER EXAMINATION AND REPAIR.
Malfunction Cause Remedy
Leaking Connection loose Check connection between hose and main and tighten it.
No Flush Water Supply Issue Check water supply for abnormality and ensure supply valve is on.
Low Flush Volume Low water pressure Please ensure the water pressure over 40 psi.
Slow refill time Please wait for at least 50 seconds after previous flush.
REPLACEMENT PARTS LIST
There will be instructions with the new replacement part.
Seat Cover Base Flush Valve Fill Valve
Filter Inlet Hose-set Fill Valve Diaphragm Seal Bowl Mounting Hardware / Plug
12" Flange

9
TECHINCAL DATA
Flow Pressure Range
Ambient Temperature Range
Water Consumption
Flush type
Net Weight
Product Dimension ( L × B × H )
Load Seat and Lid ( Maximum )
0.27 - 0.55 MPa ( 40 - 80 psi )
4 - 40 °C ( +39 °F to + 104 °F )
4.8 L ( 1.28 GPF )
Vacuum V Flush
49 kg ( 108 lbs )
725 × 386 × 486 mm ( 28 × 15 × 19⅛ inches )
150 kg ( 330 lbs )
LEGAL DIRECTIONS
This manual contains important information on the intended use, correct operation and proper maintenance of the equipment. Knowledge of and
compliance with the instructions of this manual are provided for both the safe use of the equipment and for the safety of its operation and maintenance.
In this manual, not all kinds of applications and improper manipulations are considered. In addition, attention is drawn to the following: The content of
these instructions is neither part of any previous or existing agreement, commitment or legal relationship, nor does it change from an existing agreement,
commitment or legal relationship. Any commitment by AXENT results from the respective warranty. These include the complete and authoritative
warranty obligation AXENT. The statements in this manual do not constitute an extension or a restriction of the claims under the warranty provisions. This
manual is protected by copyright. Copies and / or translations into other languages may be made only with prior written approval of AXENT.