OPERATION MAINTENANCE
II. REMOVING AND REINSTALLING/REPOSITIONING
THE ALUMINUM RAILS
1. Remove all of the Drawers
(follow the procedure I).
2. Remove the 2 screws on each side
using a #2 Phillips head screwdriver.
3. Remove the Side Plate/Rail Assembly
by pulling it forward out of the case.
4. Remove the Aluminum Rails from the
Side Plates by depressing the tab(s)
at the back of the plastic side plates
and sliding the rails rearward.
32
1
4 4
5. Reinstall the Aluminum Rails into the Side Plates in the desired position by sliding
the rails into the side plates from the back.
NOTE: The right-hand aluminum rails are dierent than the left-hand
aluminum rails, so care should be taken not to mix them up.
6. Once all the aluminum rails are installed into the side plates, slide the side plate
back into the case and re-install the 2 screws using a hand screwdriver, taking
care not to over-tighten the screws.
DO NOT USE A POWER SCREWDRIVER.
NOTE: Wheels can be replaced without removing the entire trolley assembly.
To replace a broken wheel, remove the Lock Nut on the end of the Axle, using a
7/16" open end wrench on the Lock Nut and a 5/16" open end wrench on the Axle.
Slide the Axle out. Remove wheel and reinstall new wheel.
V. WHEELS
· It is recommended that the Slide/Rail System be lubricated prior to initial use,
and cleaned and lubricated every 500 cycles during use.
· In addition, periodically inspect the drawer/slide system for debris and clean
as needed, especially during periods of heavy usage.
· The Slide/Rail system can be cleaned by removing the Drawers and/or removing
the entire Side Plate/Rail Assembly (follow the procedures above).
· Clean any debris out of the system using a brush or compressed air.
· LubricatetheSidePlates,MetalRails,andDrawersideswithdry-lmPTFEspray,
silicone lubricant, or light-weight oil.
III. DRAWER SLIDE/RAIL SYSTEM
To maintain a watertight seal, the
O-Ring Gaskets must be kept clean of
dirt and debris. If the O-Ring becomes
cut or cracked, it must be replaced.
IV. O-RING GASKETS
