Axor Citterio 39133XX1 User manual

Axor Citterio
39133XX1 Axor Citterio
39135XX1
Axor Citterio
39233XX1
Axor Citterio
39235XX1
Installation Instructions / Warranty

2
Technical data
Hole size in mounting surface
Spout 1 3/8“
Valve 1 1/4“
Max. thickness of mounting surface 1 3/16“
Max. flow rate 2.2 gpm
Operating pressure: max. 147 psi
Recommended operating press.: 14.7 - 72.5 psi
Test pressure: 232 psi
Hot water temperature: max. 176° F*
Recommended hot water temp.: 120°F - 140°F*
*Please know and follow all applicable local plumbing codes when setting the temperature on the water
heater. In Massachusetts, the water heater may be set no higher than 112oF.
39233XX1 / 39235XX1
Axor Citterio Widespread Lavatory Faucet
Axor Citterio Widespread Bidet Faucet
39133XX1 / 39135XX1
Installation Considerations
Hansgrohe recommends that this faucet be installed by a licensed, professional plumber.
This faucet requires 1/2“ supply lines (not included)
Flush the hot and cold supplies thoroughly before installing this faucet.

3
Installation
Flush the supplies thoroughly before
installation.
Install the metal washer and friction washer on
the valve. Push the valve up through the hole
in the mounting surface. Install the mounting
plate.
Rest the valve assembly on the mounting sur-
face. Tighten the screws.
Place the handle assembly over the valve with
the lever or cross in the desired off position.
Hold the lever or cross steady with one hand.
With the other hand, thread the escutcheon
down over the mounting plate.
Assemble the spout: Push the escutcheon
onto the bottom of the spout (1). Fasten the
retaining screws with a 5mm allen wrench (2).
Push the pull rod down through the spout.

4
Sit the spout on the countertop. Install the
mounting piece mounting collar.
Attach the compression Y to the bottom of the
spout fitting with the enclosed 10 mm compres-
sion fitting. The metal side of the ferrule should
point upwards. Tighten wrench tight.
Screw the connection hoses to the Y.
Attach the hoses to the valves with the enclosed
3/8“ compression fittings. Use two wrenches,
as shown, to prevent the hoses from twisting.
Connect the valves to the stops with 1/2“ supp-
ly lines (not included).
Install the drain.
Turn on the water and check all connections for
leaks.
3/4”
7/16”

5
Install the pop-up drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap
the threads with two layers of Teflon tape and
replace.
Install the white, flexible sealing gasket to the
flange. Place it in the sink outlet.
From under the sink, install the black mack gas-
ket, white friction ring and retainer nut to the
flange. Do not tighten the nut against the bottom
of the sink at this time.
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
Tighten the retainer nut.
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes
through the loop in the bottom of the height
adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the
horizontal rod.
Attach the swivel connector to the end of the
vertical rod. Position as desired and tighten
with a small, flathead screwdriver.
plunger
flange
sealing gasket
mack gasket
friction ring
retainer nut
horizontal rod
height adjuster
pivot ball nut
swivel connector
vertical rod
tee
tailpiece

6
Replacement parts
1 cold handle, cross 39291XX0
2 hot handle, cross 39292XX0
3 lever handle, cold 39291XX0
4 lever handle, hot 39292XX0
5 cold cartridge 94008000
6 hot cartridge 94009000
7 aerator 96673000
8 aerator 94005XX0
9 spout 96674XX0
10 spout 96675XX0
11 lift rod 96676XX0
12 fixation set 96016000
13 connection hose 94071001
14 10 mm compression ftg 94158000
15 3/8“ compression ftg 88513000
16 pivot ball for bidet 96050XX0
XX = Color code
00 = chrome
82 = brushed nickel
1
5
2
6
12
13
11
7
9
10 3
48
14
15
16

7
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to
Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or
Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship
as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product that proves defective
because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a
replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of
the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a
consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you
own the product and the home in which the product is originally installed. If you purchased the product for use primarily for any other purpose,
Cleaning Recommendation for Hansgrohe Products
Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the
market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when
cleaning.
Cleaning Materials for Faucets and Showers
Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the following points
when cleaning faucets and showers:
•Only use cleaning materials which are explicitly intended for this type of application.
•Never use cleaning materials which contain hydrochloric, formic, phosphoric, or acetic acid, as they cause considerable
damage.
•Never mix one cleaning material with another.
•Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge pads,
or micro fiber cloths.
Cleaning Instructions for Faucets and Showers
Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the following points:
•Clean the faucets and showers as and when required
•Use the amount of cleaning product and the amount of time recommended by the manufacturer. Do not leave the cleaner
on the fixture longer than necessary.
•Regular cleaning can prevent calcification.
•When using spray cleaners, spray first onto a soft cloth or sponge. Never spray directly onto the faucet as droplets can
enter openings and gaps and cause damage.
•After cleaning, rinse thoroughly with clean water to remove any cleaner residue.
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note: if the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced or injury could result.
Damage caused by improper treatment is not covered under the warranty.

Hansgrohe, Inc. •1490 Bluegrass Lakes Parkway •Alpharetta, GA 30004
Tel. [phone] •Fax [phone]
www.hansgrohe-USA.com
US - Installation Instructions •Part No. 90614001 •Revised 08/2007
including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products,
and (ii) for 5 years, with respect to AXOR products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper maintenance, misuse, abuse,
negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no-rinse” cleaning products, or the use of the
product in any manner contrary to the product instructions. (3) Conditions in the home such as excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for installation or reinstallation
of the product (including but not limited to proper packaging and shipping costs), or for installation or reinstallation of the product.
D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your Hansgrohe retailer, or contact Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Toll-free [phone].
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass Lakes
Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS
THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY
OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES,
ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply
to you. This warranty gives you specific legal rights, and you may have other rights which vary from State to State. You may be required by
law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the
Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing,
always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions at
any time about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us or call us toll-free at
800 334 0455.