Axor High Spout 38030XX1 User manual

Installation Instructions / Warranty
Uno2
38030XX1
02/2005 9.05406.01

2
Uno2Single Control Lavatory Faucet
38030XX1
Technical Specification
Maximum water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Maximum hot water temp. 176o*
Recommended hot water temp 120o- 140o*
Max. flow rate @ 45 psi 2.2 gpm
Max. deck thickness 1 5/8”
Hole size in deck 1 3/8”
Installation considerations:
•Hansgrohe recommends that this faucet be installed by a licensed
professional plumber.
•The supply hoses installed on this unit connect to the supply stops with
standard 3/8" compression fittings. Supply stops and 3/8" compression
fittings are not included.
*Many municipalities require that the water heater be set no higher than 120o. Please know and follow all applicable
plumbing codes when setting the temperature on the water heater.

3
Installation Instructions
sealing ring
friction washer
metal washer
mounting nut
tensioning screws
•Sit the faucet with black sealing ring in the faucet hole on top of the
mounting surface.
•From beneath, install the friction washer, metal washer, and mounting nut.
Tighten the mounting nut, taking care not to overtighten.
•Check the position of the faucet. When satisfied, use a slot-headed
screwdriver to tighten the tensioning screws.
•Feed the pull rod through the hole in the back of the faucet body.
•Attach the supply lines to the supply stops with standard 3/8" compression
fittings (not included)

4
Re-set the high temperature limit stop (optional)
This step should be taken if the faucet is to be used by small
children or others who should be protected from scalding.
•Pull out the screw cover, located on the
bottom of the handle.
•Use a 3 mm allen wrench to loosen the
set screw 2 complete turns.
•Pull off the nut cover and the green high temperature limit stop ring.
•Reinstall the high temperature limit stop ring so that the black positioning pin
is in the notch corresponding to the desired high temperature. The
temperatures shown in the diagram assume an incoming cold water
temperature of 50oF and an incoming hot water temperature of 140o.
•Center and replace the nut cover.
•Replace the handle.
•Tighten the set screw.

5
Install the pop-up drain
•Remove the plunger assembly.
•Unscrew the drain outlet flange from the tee.
•Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread
tape and replace.
•Install the white, flexible sealing gasket to the flange. Sit it in the sink outlet.
•From under the sink, install the black mack gasket, white friction ring , and
retainer nut to the flange. Do not tighten the nut against the bottom of the sink
at this time.
•Thread the tee and tailpiece to the flange. The pivot must face the faucet. If
necessary, turn the drain assembly.
•Tighten the retainer nut.
•Sit the plunger assembly in the drain.
•Install the horizontal rod so that the end goes through the loop in the bottom
of the height adjuster.
•Install and hand tighten the pivot ball nut.
•Attach the swivel connector to the end of the horizontal rod.
•Attach the swivel connector to the end of the vertical rod. Position as
desired, and tighten with a small, flathead screwdriver.